HP StorageWorks 1000 - Modular Smart Array Manual de instalação - Página 2

Procurar online ou descarregar pdf Manual de instalação para Interruptor HP StorageWorks 1000 - Modular Smart Array. HP StorageWorks 1000 - Modular Smart Array 18 páginas. Power supply, computer
Também para HP StorageWorks 1000 - Modular Smart Array: Manual da rede (8 páginas), Lista de apoio (34 páginas), Manual de prevenção de erros (12 páginas), Livro Branco Técnico (12 páginas), Atualização do firmware (9 páginas), Visão geral (20 páginas), Manual de instalação (2 páginas), Números de telefone de apoio (19 páginas), Manual de referência (48 páginas), Manual de Administração (40 páginas), Nota de lançamento (13 páginas), Instruções de início rápido (8 páginas), Manual de início rápido (7 páginas), Nota de lançamento (5 páginas), Instruções de substituição (4 páginas), Livro Branco (13 páginas), Resumo da tecnologia (15 páginas), Especificação rápida (17 páginas), Especificação (49 páginas), Manual de iniciação (34 páginas), Instalação (4 páginas), Manual de instruções de desmontagem (9 páginas), Manual de programação (8 páginas)

August 2003

Linux is a registered trademark of Linus Torvalds in several countries. UNIX is a trademark of

The Open Group in the United States and other countries. All other product names mentioned

herein may be trademarks of their respective companies.

HP shall not be liable for technical or editorial errors or omissions contained herein. The

information in this document is provided "as is" without warranty of any kind and is subject to

change without notice. The warranties for HP products are set forth in the express limited

warranty statements accompanying such products. Nothing herein should be construed as

constituting an additional warranty.

FCC Notice

Part 15 of the Federal Communications Commission (FCC) Rules and Regulations has

established Radio Frequency (RF) emission limits to provide an interference-free radio

frequency spectrum. Many electronic devices, including computers, generate RF energy

incidental to their intended function and are, therefore, covered by these rules. These rules place

computers and related peripheral devices into two classes, A and B, depending upon their

intended installation. Class A devices are those that may reasonably be expected to be installed

in a business or commercial environment. Class B devices are those that may reasonably be

expected to be installed in a residential environment (i.e., personal computers). The FCC

requires devices in both classes to bear a label indicating the interference potential of the device

as well as additional operating instructions for the user.

FCC Rating Label

The rating label on the device shows which class (A or B) of the equipment. Class B devices

have an FCC ID on the label. Class A devices do not have an FCC ID on the label. After you

determined the class of the device, refer to the following corresponding statement.

Class A Equipment

This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a commercial environment. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference, in which

case the user will be required to correct the interference at personal expense.