HP StorageWorks 2/16 - SAN Switch Nota de lançamento - Página 13

Procurar online ou descarregar pdf Nota de lançamento para Interruptor HP StorageWorks 2/16 - SAN Switch. HP StorageWorks 2/16 - SAN Switch 32 páginas. Fabric os commands
Também para HP StorageWorks 2/16 - SAN Switch: Manual de atualização (9 páginas), Manual de instruções de instalação (20 páginas), Manual do utilizador (22 páginas), Notas de versão do firmware (14 páginas), Nota de lançamento (16 páginas), Manual de instalação (14 páginas), Nota de lançamento (10 páginas), Manual de referência rápida (5 páginas)

For each hop, the routing information output includes the following:

For each hop, statistics are broken down into basic and extended. They are

reported below the routing information, separated into input port statistics and

output port statistics. For each port, they are further separated into transmit and

receive statistics. Statistics are not reported for the embedded port. Some values

are measured over multiple time intervals. For example, the output line utilization

in bytes per second is calculated over both a 1-second period and over a 64-second

period. this gives an idea of both the current line utilization and the utilization

over a longer period. The time interval is listed in parentheses after the value's

description.

Maximum Hop Count

The pathInfo command uses a special frame that is sent hop-by-hop from the

source switch to the destination switch, collecting routing and statistical

information at every hop. To prevent such a frame from looping forever when an

error occurs, the command specifies a maximum number of hops for the frame to

traverse.

The hop count includes all hops in the direct path from source to destination, and

also all the hops in the reverse path, if the tracing of the reverse path is requested.

The default value for the maximum hop count is 25.

SAN Switch 2/16 Fabric OS 3.1.2 Release Notes

Hop

The hop number (the local switch is hop 0.

In Port

The port (or area) from which the frames come. For hop 0,

the source port. For a switch with blades, this is specified s

the area number; otherwise, as the port number.

Domain ID

The domain ID of the switch.

Name

The name of the switch

Out Port

The output port that the frames take to reach the next hop.

For the last hop, this is the destination port or area. For a

switch with blades, this is specified as the area number;

otherwise, as the port number.

The bandwidth of the output ISL in Gbps. It does not apply

to the embedded port.

Cost

The cost of the link used by FSPF routing protocol. It

applies only to an E_Port.

New Command in v3.1.2