HP StorageWorks 8B - FC Entry Switch Nota de lançamento - Página 21

Procurar online ou descarregar pdf Nota de lançamento para Interruptor HP StorageWorks 8B - FC Entry Switch. HP StorageWorks 8B - FC Entry Switch 26 páginas. Fabric os release notes version 3.0.1b
Também para HP StorageWorks 8B - FC Entry Switch: Manual de atualização (9 páginas), Manual de instruções de instalação (20 páginas), Manual do utilizador (22 páginas), Notas de versão do firmware (14 páginas), Manual de instalação (14 páginas), Manual (50 páginas), Manual do utilizador (44 páginas), Manual do utilizador (44 páginas), Manual do utilizador (38 páginas), Manual do utilizador (38 páginas), Manual do utilizador (37 páginas), Manual do utilizador (30 páginas), Nota de lançamento (16 páginas)

Web tools, Java Bug

If a dialog box is displayed from the switch admin window of the Web Tools and

the user selects another dialog box from Web Tools, a Windows display error

results.

This display error is a known defect in Java 1.3. The issue is documented at the

following location:

To avoid the display error, open only one dialog box at a time or launch another

switch admin session in a separate window.

Zoning

To use Zoning in a non-RCS (Reliable Commit Service) mode fabric (in a fabric

containing switches with a firmware version other than v2.6.1x, v3.1.x and

v4.1.x), it is recommended that all appropriate Zoning licenses be installed on all

the switches in the fabric before attempting to bring a switch into the fabric.

Additionally, if the Zoning license has been removed, the user must make sure it is

re-installed properly on the affected switch before attempting a cfgenable

zoning operation. Failure to follow these steps can cause inconsistency of Zoning

configuration on the affected switches should a zoning operation be attempted

from a remote switch in the fabric. On the affected switches, an error message

appears on the console or Telnet session, indicating that the zoning license is

missing.

Note:

or errDump command.

Loop Devices

Some loop devices do not link up to the fabric. This problem occurs when the

switch does not send enough LIPs to transitions from the AL-PA sequence to the

the OLD_Port sequence.

To avoid the issue, set the port as a G-Port by using the portCfgGPort

command.

SAN Switch 2/8 Version 3.1.x Release Notes

http://java.sun.com/

You can also see the error message by performing either the errShow

Issues and Workarounds

(bug ID 4763605).