HP XP20000/XP24000 Manual de configuração - Página 19

Procurar online ou descarregar pdf Manual de configuração para Interruptor HP XP20000/XP24000. HP XP20000/XP24000 36 páginas. Hp storageworks xp disk array configuration guide: vmware (a5951-96106, september 2010)
Também para HP XP20000/XP24000: Nota de lançamento (13 páginas), Manual de integração (29 páginas), Nota de lançamento (4 páginas), Manual do Administrador (50 páginas), Manual de configuração (42 páginas), Manual de configuração (40 páginas), Manual de configuração (40 páginas), Manual de configuração (36 páginas), Manual de configuração (36 páginas), Manual de configuração (30 páginas), Nota de lançamento (5 páginas), Manual de configuração (46 páginas), Manual de configuração (46 páginas), Manual de referência (46 páginas), Manual de configuração (40 páginas), Manual de configuração (44 páginas), Manual de configuração (38 páginas), Manual de configuração (34 páginas), Manual de configuração (30 páginas), Manual de configuração (30 páginas)

Imprimir página
HP XP20000/XP24000 Manual de configuração

2 Troubleshooting

This section includes resolutions for various error conditions you may encounter.
If you are unable to resolve an error condition, ask your HP support representative for assistance.

Error conditions

Depending on your system configuration, you may be able to view error messages (R-SIMS) as follows:
In XP Remote Web Console (Status tab)
In XP Command View Advanced Edition Software (Alerts window)
In XP Command View (Event History or Event Notification windows) (XP arrays only)
Table 6 Error conditions
Error condition
The logical devices are not recog-
nized by the host.
The host does not reboot properly
after hard shutdown.
Physical volumes cannot be created.
Logical volumes cannot be created.
A file system is not mounted after re-
booting.
The disk array performs a self reboot
because the disk array was busy or
it logged a panic message.
Recommended action
Verify the following:
The READY indicator lights on the disk array are ON.
Fiber cables are correctly installed and firmly connected.
The TIDs/WWNs on each bus are unique. Do not install two
devices with the same ID on the same bus. Recheck the buses for
new devices.
The maximum number of LUSE devices per port has not been ex-
ceeded.
The disk array host mode is set correctly.
If you power off the host without executing the shutdown process, wait
three minutes to allow the disk array's internal timeout process to purge
queued commands. If the host restarts while the disk array is processing
queued commands, the host may not reboot successfully.
Verify that the disk array logical devices are correctly formatted.
Verify that the volume capacity for OPEN-x volumes is not greater than
the maximum capacity allowed. See
emulations" on page 25.
Verify that the capacity of the volume group is not less than the total
capacity of the partitioned logical volume.
Verify that the host was restarted correctly.
Verify that the file system attributes are correct.
Reboot the host.
XP Disk Array Configuration Guide for Windows
"Disk array supported
19