HP XP20000/XP24000 Manual de configuração - Página 14

Procurar online ou descarregar pdf Manual de configuração para Interruptor HP XP20000/XP24000. HP XP20000/XP24000 40 páginas. Hp storageworks xp disk array configuration guide: vmware (a5951-96106, september 2010)
Também para HP XP20000/XP24000: Nota de lançamento (13 páginas), Manual de integração (29 páginas), Nota de lançamento (4 páginas), Manual do Administrador (50 páginas), Manual de configuração (42 páginas), Manual de configuração (40 páginas), Manual de configuração (40 páginas), Manual de configuração (36 páginas), Manual de configuração (36 páginas), Manual de configuração (30 páginas), Manual de configuração (36 páginas), Nota de lançamento (5 páginas), Manual de configuração (46 páginas), Manual de configuração (46 páginas), Manual de referência (46 páginas), Manual de configuração (44 páginas), Manual de configuração (38 páginas), Manual de configuração (34 páginas), Manual de configuração (30 páginas), Manual de configuração (30 páginas)

Imprimir página
HP XP20000/XP24000 Manual de configuração
•
Creating the file systems
•
Creating the mount directories
•
Creating the mount table
•
Verifying file system operation

Installing and configuring the disk array

The HP service representative performs these tasks:
•
Assembling hardware and installing software
•
Loading the microcode updates
•
Installing and formatting devices
After these tasks are finished, you will use XP Remote Web Console, XP Command View (XP arrays
only), XP Command View Advanced Edition Software, or XP Array Manager to complete the remaining
tasks listed below. If you do not have these programs, your HP service representative can perform
these tasks for you.

Setting the host mode and host group mode for the disk array ports

After the disk array is installed, you must set the host mode for each disk array port to match the host
OS. Set the host mode using LUN Manager in XP Remote Web Console (shown), XP Command View
(XP arrays only), or XP Command View Advanced Edition Software. If these are not available, the
HP service representative can set the host mode using the SVP. The host mode setting for Linux is 00.
Test.
CAUTION:
The correct host mode must be set for all new installations (newly connected ports) to Linux hosts. Do not
select a mode other than 00 for Linux. Changing a host mode after the host has been connected is disruptive
and requires the server to be rebooted.
When a new host group is added, additional host group modes (options) may be configured. The
storage administrator must verify if an additional host group mode is required for the host group.
14
Installing and configuring Linux for the XP disk array