HP XP20000/XP24000 Manual de configuração - Página 12

Procurar online ou descarregar pdf Manual de configuração para Interruptor HP XP20000/XP24000. HP XP20000/XP24000 38 páginas. Hp storageworks xp disk array configuration guide: vmware (a5951-96106, september 2010)
Também para HP XP20000/XP24000: Nota de lançamento (13 páginas), Manual de integração (29 páginas), Nota de lançamento (4 páginas), Manual do Administrador (50 páginas), Manual de configuração (42 páginas), Manual de configuração (40 páginas), Manual de configuração (40 páginas), Manual de configuração (36 páginas), Manual de configuração (36 páginas), Manual de configuração (30 páginas), Manual de configuração (36 páginas), Nota de lançamento (5 páginas), Manual de configuração (46 páginas), Manual de configuração (46 páginas), Manual de referência (46 páginas), Manual de configuração (40 páginas), Manual de configuração (44 páginas), Manual de configuração (34 páginas), Manual de configuração (30 páginas), Manual de configuração (30 páginas)

If host mode option 33 is not enabled, for all LUNs, determine the device number as follows

(once OpenVMS sees the XP disks):

OpenVMS device name ($1$dgaxxx), where xxx = CU with LDEV appended (Then convert the

created number from hex to decimal)

Example

For a LUN with a CU of 2 and an LDEV of 59:

CU with LDEV appended = 259

259 hex = 601 decimal

The example LUN is presented to OpenVMS as $1$dga601.

For all LUNs if host mode option 33 is used, the DGA device number is the UUID value for the

LUN.

Once all paths are defined, use the SYSMAN utility on each OpenVMS system in the SAN to

discover the array ports and LUNs just added.

For a single system:

$run sys$system:sysman io autoconfigure/LOG

For all systems in an OpenVMS cluster:

$run sys$system:sysman

sysman> set environment/cluster

sysman> io autoconfigure/log

Verify the online status of the XP LUNs, and confirm that all expected LUNs are shown online.

Setting the host mode for the disk array ports

After the disk array is installed, you must set the host mode for each host group that is configured on

a disk array port to match the host OS. Set the host mode using LUN Manager in XP Remote Web

Console (shown) or P9000 or XP Command View Advanced Edition Software. For procedures, refer

to the applicable user guide available at http://www.hp.com/support/manuals. If these are not

available, the HP service representative can set the host mode using the SVP.

The required host mode setting for OpenVMS is 05.

When a new host group is added, additional host group modes (options) can be configured. The

storage administrator must verify if an additional host group mode is required for the host group.

Installing and configuring OpenVMS for the XP family of disk arrays