Diamond Products CC1600 Manual do operador - Página 3

Procurar online ou descarregar pdf Manual do operador para Serra Diamond Products CC1600. Diamond Products CC1600 16 páginas. Wall saw

Your Diamond Products CC1600 wall saw has been designed to be as safe and efficient

as possible. However, wall sawing can be hazardous if proper safety precautions are not

taken and operating instructions are not followed carefully. Study this manual and

remember all warnings, cautions, and tips. Keep a copy of the manual near the job site

to allow the operator to review any section as needed.

• Read and understand instructions before operating saw.

• Wear proper safety clothing, including hardhat, respirator, gloves, and safety glasses.

Avoid loose fitting clothing.

• Sturdy boots with non-skid soles aid in providing proper footing. Steel-toed safety

boots are recommended.

• Cutting steel reinforcing bar produces sparks, avoid clothing of flammable material.

• Know how to stop the saw quickly in an emergency.

• Noise levels can be very high. Wear OSHA-approved hearing protection at all times

while the saw is operating.

• Keep all parts of your body away from the blade and all other moving parts.

• Be sure that the blade guard is the correct type (flush cut or standard), is set to

protect the operator, and is mounted securely on the saw.

• Do not operate the wall saw if you are under the influence of drugs or alcohol.

• Inspect the blade carefully before use. The blade should have no cracks, nicks, or

flaws. The arbor hole should be undamaged. Use only steel centered wet cutting

diamond blades manufactured for use on wall saws and recommended for your saw.

• Do not use dry cutting diamond blades, high-speed steel blades, carbide tipped

blades, or abrasive blades.

• Only use blades marked with a maximum operating speed higher than the blade shaft

speed.

• Cut only stone, concrete, reinforced concrete, and masonry materials. Do not cut

materials such as wood, glass, or plastic.

• Inspect flanges for damage, excessive wear, and cleanliness before mounting the

blade. The blade should fit snugly on a clean, undamaged shaft.

• Hydraulic power units are designed with the ability to vary the blade speed. Never

operate the saw at a speed higher than the maximum safe allowable speed indicated

on the blade. If you are unsure of the operating speed, contact the manufacturer or

Diamond Products.

• Always keep the blade guard in place, seated firmly on the blade guard support.

• Avoid getting in direct line with the blade.

Chapter 1

SAFETY

SAFETY WARNINGS