Diamond Products CC500M Manual do operador - Página 6

Procurar online ou descarregar pdf Manual do operador para Serra Diamond Products CC500M. Diamond Products CC500M 7 páginas. Core cut masonry saw

5. Ensure that extension cord gauge matches its length, as shown in chart. Undersize

extension cords may damage motor. Whenever possible, use 230 volts. Inspect

cord for cuts, knicks, or exposed wires. Replace cord if damaged.

6. If you experience any problems with your electric motor or gas engine, contact

Diamond Products for the nearest Authorized Service Center. If motor or engine is

serviced by an unauthorized service center, the warranty will be voided.

7. When transporting saw, remove cutting head from frame. Vibration during transport

could cause the cutting head to pound in the frame, causing the head to come out of

alignment. Always remove the blade when transporting.

8. Make sure that V-belts are always tensioned properly. Replace worn belts in sets.

9. Slots in cutting head are provided to keep blade aligned horizontally and vertically

with cut line on conveyor cart. Loosen lock nuts on blade shaft bearings and tilt shaft

towards appropriate direction. Tighten lock nuts when blade is properly aligned with

conveyor cart.

10. Blade should mount snugly on arbor. If blade fits loosely on arbor, or if arbor

shoulder is grooved, the inner flange must be replaced. Otherwise, blade life will be

shortened dramatically.

11. Blade flanges must have minimum outside diameter of 3 7/8". Replace worn flanges

immediately because they can shorten blade life or cause blade to break.

12. Frequently inspect conveyor cart. Replace wood insert and wheels often.

13. Replace bronze bearing in blade guard pivot plate if blade guard does not pivot

properly.

14. Clean air cleaner daily on saws with gas engine. See engine manual for

maintenance instructions.

15. For additional engine care, see engine manual.

ABOUT DIAMOND BLADES

Diamond Products manufactures diamond blades suited for your specific cutting needs -

brick, concrete block, tile, refractory etc. Contact a Diamond Products Customer Service

Representative to help determine what blade is right for your specific needs

at 1-800-321-5336 or 1-800-421-3157.