Diamond Products Core Bore Manual - Página 5

Procurar online ou descarregar pdf Manual para Perfurar Diamond Products Core Bore. Diamond Products Core Bore 9 páginas.

Imprimir página

17. Disconnect power. When not in use, before ser- vicing, and when changing accessor ie

s or Bits.

18. Form a habit of checking to see if wrenches are removed from tool before turning it

on.

19. Avoid accidental starting. Make sure ON/OFF Switches are in OFF position before

plugging in Power Cord.

20. Check for damaged parts.

• Check for alignment of moving parts, binding of moving parts, mounting, and any othe

r condi- tions that may affect its operation. A guard or other part that is damaged

should be properly repaired or replaced by an authorized servicecenter unless otherwi

se indicated elsewhere in this instruction manual.

• H a v e d e f e c t i v e S w i t c h e s r e p l a c e d b y a n authorized service center.

• Do not use tool if Switch does not turn it on or off.

21. When releasing Carriage Locking Handle, main- tain a firm grip on Feed Handle to

prevent Feed Handle from revolving due to weight of Drill.

Note: "Save these instructions."

Set-Up Instructions for Securing Machine

Caution: It is very important that the Drill ing Machine is properly secured

to the work surface. Movement during drilling will cause chatter of Bit against

the work sur- face, fracturing diamonds. Bit may also bind in hole, causing

damage to the Bit. The methods for anchoring are as follows: follows:

Bolt Anchor Method-to-Floor

1. Measure distance from center of Anchor Bolt slot in Base (Fig. 2) to center of Drill S

pindle (Fig. 4).

2. Mark and measure from center of hole on floor to be drilled, to spot where Anchor Bolt

hole will be drilled.

3. Drill and set 1/2 inch Anchor Bolt. Place Drilling

Machine over anchor hole and hand tighten bolt.

4. When anchoring to brick or block walls, you MUST drill thru the brick or block and use all

thread to secure the machine to the wall.

5. Adjust 4 Leveling Screws (Fig. 4) to stabilize Base and plumb Mast. Secure Machine by

tightening Anchor Bolt.

Bolt Anchor Method-to-Wall

Use the same Bolt Anchor Method procedure to anchor as above.

Warning: You must use additional precautionary procedures to assure safety

of operator. T h i s i n v o l v e s f a s t e n i n g a c h a i n t o Machine and securing

chain to avoid fall- ing. DO NOT use the Vacuum to secure the machine to the

wall or ceiling , as serious injury could result.

Water

can

Note:

Water

fed

through

supplied

by a

standard garden

Inlet

Hose, down inside of

hose or by a

Bit,

washing cuttings from under Bit

Pressure

Tank.