Diamond Products CSE12 Lista de peças e manual do operador - Página 7
Procurar online ou descarregar pdf Lista de peças e manual do operador para Motosserra Diamond Products CSE12. Diamond Products CSE12 20 páginas. Electric chainsaw
Também para Diamond Products CSE12: Manual do operador (20 páginas)
Imprimir página
SAFETY DEVICES
1.
Hand Guard: Protects the hand from debris and helps to block a broken chain. Never operate without the
hand guard in place. Replace if damaged.
2.
Splash Flap: Protects from thrown debris and slurry. Never operate without the splash flap in place.
Replace if damaged.
ELECTRICAL CONNECTION
The network voltage must conform to the voltage indicated on the tool name plate.
Under no circumstances should the tool be used when the power supply cable is damaged. A damaged
cable must be replaced immediately by an authorized Customer Service Center. Do not try to repair the
damaged cable yourself. The use of damaged power cables can lead to an electric shock.
INSTALLING THE GUIDE BAR AND CHAIN
1.
With the 2 side cover nuts removed and the side cover removed, slacken the tension adjustor by turning
anticlockwise.
2.
Slip the guide bar into position over the studs with the hole
engaged with the adjustor pin. (the bar is symmetrical and may
be installed with either side up)
3.
Place the chain around the drive sprocket first, ensuring that
the drive links engage the sprocket teeth.
4.
Starting from the drive sprocket end, loop the chain around the
guide bar nose sprocket, ensuring that the drive links engage
with the guide bar groove and remain engaged with the sprockets.
5.
Place the side cover in position and thread on the 2 side cover nuts, leaving them finger tight only (to
allow the tension adjustor to be adjusted). They will be tightened fully after tensioning according to the
instructions below.
Guide Bar
Side Cover Nuts