Panasonic PLC-XP40 Manual do Proprietário - Página 39
Procurar online ou descarregar pdf Manual do Proprietário para Projetor Panasonic PLC-XP40. Panasonic PLC-XP40 44 páginas. Multimedia projector
Imprimir página
When life of Projection Lamp of this projector draws to an end, LAMP REPLACEMENT indicator lights yellow. When a
projected image becomes dark or color of an image becomes unnatural, replacement of Projection Lamp is required.
CAUTION
For continued safety, replace with a lamp
assembly of same type.
Allow a projector to cool for at least 45
minutes before you open Lamp Cover. Inside
of a projector can become very hot.
Follow these steps to replace lamp assembly.
Turn off a projector and disconnect AC plug. Allow a projector to
1
cool for at least 45 minutes.
Remove 2 screws with a screwdriver and open Lamp Cover.
2
3
Loosen 2 screws with a screwdriver and pull out Lamp Assembly
by grasping Handle.
4
Replace Lamp Assembly with a new one and tighten 2 screws
back. Make sure that Lamp Assembly is set properly. Replace
Lamp Cover and tighten 2 screws.
Connect AC Power Cord to a projector and turn it on.
5
Reset Lamp Replace Counter (refer to section "Lamp Replace
6
Counter" below).
NOTE : Do not reset Lamp Replace Counter when Projection
Lamp is not replaced.
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through your dealer. When ordering Projection Lamp, give following
information to dealer.
Model No. of your projector
Replacement Lamp Type No. : POA-LMP38
Be sure to reset Lamp Replace Counter when Lamp Assembly is replaced. When Lamp Replace Counter is reset, LAMP
REPLACE Indicator stops lighting.
Turn projector on, press MENU button and ON-SCREEN MENU will appear. Press POINT LEFT/RIGHT button(s) to
1
move a red frame pointer to SETTING Menu icon (refer to page 35, 36).
Press POINT DOWN button to move a red frame pointer to "Lamp counter reset" and then press SELECT button.
2
Message "Lamp replace counter reset?" is displayed. Move pointer to [Yes] and then press SELECT button.
Another confirmation dialog box appears and select [Yes] to reset Lamp Replace Counter.
3
Do not reset Lamp Replace Counter except after Projection Lamp is replaced.
LAMP REPLACEMENT
: PLC-XP40
(Service Parts No. 610 293 5868)
LAMP REPLACE COUNTER
CAUTION
Do not drop a lamp assembly or touch a glass
bulb! Glass can shatter and may cause injury.
LAMP
ASSEMBLY
APPENDIX
LAMP COVER
HANDLE
39