Panasonic PLC-XP40 Manual do Proprietário - Página 8

Procurar online ou descarregar pdf Manual do Proprietário para Projetor Panasonic PLC-XP40. Panasonic PLC-XP40 44 páginas. Multimedia projector

PREPARATION

This projector uses nominal input voltages of 100-120 V or 200-240

V AC. This projector automatically selects correct input voltage. It

is designed to work with single-phase power systems having a

grounded neutral conductor. To reduce risk of electrical shock, do

not plug into any other type of power system.

Consult your authorized dealer or service station if you are not sure

of type of power supply being in use.

Connect a projector with a peripheral equipment before turning a

projector on. (Refer to pages 11 ~ 13 for connection.)

CAUTION

For safety, unplug AC Power Cord when an appliance is not

used.

When this projector is connected to outlet with AC Power Cord,

an appliance is in Stand-by Mode and consumes a little electric

power.

NOTE ON POWER CORD

AC Power Cord must meet requirement of country where you use a projector.

Confirm an AC plug type with chart below and proper AC Power Cord must be used.

If supplied AC Power Cord does not match your AC outlet, contact your sales dealer.

Projector side

To POWER CORD

CONNECTOR on your

projector.

SETTING-UP PROJECTOR

For the U.S.A. and Canada

Ground

To the AC Outlet.

(120 V AC)

Connect AC Power Cord (supplied) to a projector.

AC outlet must be near this equipment and must

be easily accessible.

AC Outlet side

For Continental Europe

To the AC Outlet.

(200 - 240 V AC)

For the U.K.

To the AC Outlet.

(200 - 240 V AC)