Diamond Tech DL 5000 Manual de operação - Página 2

Procurar online ou descarregar pdf Manual de operação para Serra Diamond Tech DL 5000. Diamond Tech DL 5000 8 páginas. Diamond laser band saw

Imprimir página

DL5000 INSTRUCTION MANUAL

Before You Begin

Read and follow all instructions carefully.

• After unpacking all components, assemble band saw on a firm level surface to prevent saw from

tilting and rocking.

• Be sure the power switch is in the OFF position before plugging in the band saw.

• Always disconnect band saw from electrical outlet before setting up or servicing.

• Wear proper apparel. Never wear loose fitting clothes, neckties, jewelry and gloves that may get

caught in moving parts.

• Remove all wrenches before using band saw. Leaving wrenches attached while operating this tool

may result in damage to the machine and/or operator.

• Always wear safety goggles. Everyday eyeglasses have only impact resistant lenses; they are not

safety glasses.

• Never turn on band saw while glass or working materials are touching the blade.

• Always hold material being cut firmly on cutting table.

• Feed materials at a slow easy pace into the blade. Avoid sudden twisting of the blade, which may

cause kinking or breaking.

• Keep out of reach of children.

• Never leave saw running unattended. Turn power oFF when not in use.

• Do not operate while under the influence of medication or alcohol.

• To ensure top performance keep band saw properly maintained.

Contents

Your Diamond Laser 5000

assembled. carefully remove saw and parts from the

packaging.

1-Band saw Body

2-cutting Table

3-recirculating water pump and valve

4-Detachable water reservoir

5-straight edge/angle cutting Guide

6-adjusting wrenches

7-extra Diamond Laser Band saw Blade

Assembly Instructions

A. Table Installation

1) remove table mounting set screws and washers from the table

mounting block directly behind the blade (Fig.1). Loosen and remove

the table alignment screw and wingnut located on the front of the cutting

table blade slot (Fig.2).

2) while holding the table with the slot opening directly behind the blade,

carefully slide the diamond blade through the slot.

3) secure cutting table to the mounting block with the table mounting

set screws. return alignment screw to the front of the cutting table and

tighten in place with the wingnut positioned under table.

PAge 1

has been shipped partially

™

Fig.1