Panasonic PT-F100NT Ficheiro de especificações - Página 8
Procurar online ou descarregar pdf Ficheiro de especificações para Projetor Panasonic PT-F100NT. Panasonic PT-F100NT 12 páginas. Lcd projector
Também para Panasonic PT-F100NT: Especificações (16 páginas), Manual de configuração e operação (37 páginas), Dimensões (1 páginas)
Imprimir página
S
F
P
E
C
I
L
LCD Projector
Serial connector
The serial connector complies with RS-232C. To control the projector from a personal computer, com-
mands must be input through communication software, based on the format and satisfying the commu-
nication conditions shown below.
Pin assignments and signal names
6
9
1
5
D-sub HD 9-pin, female
Communication conditions (factory setting)
Signal level
Synchronization method
Baud rate
Parity
Character length
Stop bit
X parameter
S parameter
Basic format
Transmission from the computer begins with STX, then the ID, command, parameter, and ETX are sent
in this order. Add parameters according to the details of control.
STX
C1 C2 C3
Start
(1 byte)
Command
(3 bytes)
(Control and/or query commands)
CAUTIION
It may not be possible to send or receive commands for about 10 to 60 seconds when the lamp is first turned on. If this occurs, wait for 60 seconds, then
try sending or receiving again. When sending multiple commands, be sure to wait for at least 0.5 second after receiving a response from the projector
before sending the next command. Additional time is sometimes required for response due to processing inside the projector. Set the time-out period for
command response to 10 seconds or more.
NOTE:
If a wrong command is received, the projector will send an ER401 command to the computer.
When sending commands without parameters, a colon (:) is not necessary.
Cable specifications
As of May 2007
E
No.
Signal name
Description
1
–
NC
2
TXD
Send data
3
RXD
Receive data
4
–
Connected internally
5
GND
Ground
RS-232C-compliant
Start-stop synchronization
9,600 bps
None
8 bits
1 bit
None
None
:
P1 P2 P3 P4
Colon
Parameter
(1 byte)
(1-4 bytes)
Projector
1
NC
2
3
4
NC
5
6
DSR
7
8
9
NC
PT-F100NT
No.
Signal name
Signal name
6
–
NC
7
CTS
Connected internally
8
RTS
Connected internally
9
–
NC
* Effective when connected to a PC having proper functions.
ETX
End
(1 byte)
PC (DTE)
NC
1
2
3
NC
4
5
6
NC
7
8
9
NC
< 8 >