Panasonic PT-LB10NTU - Mobile Proj XGA 2000 Lumens 4.9LBS Cross Platform Wrls Manual de Instruções - Página 12
Procurar online ou descarregar pdf Manual de Instruções para Projetor Panasonic PT-LB10NTU - Mobile Proj XGA 2000 Lumens 4.9LBS Cross Platform Wrls. Panasonic PT-LB10NTU - Mobile Proj XGA 2000 Lumens 4.9LBS Cross Platform Wrls 33 páginas. Micro portable wireless xga lcd projector
Também para Panasonic PT-LB10NTU - Mobile Proj XGA 2000 Lumens 4.9LBS Cross Platform Wrls: Especificações (4 páginas)
Imprimir página
Connecting to video equipment
Computer for control use
D-sub15-pin (male) - BNCx5 (male) adapter cable
Red (connect to P
Blue (connect to P
Green (connect to Y signal connector)
Serial adapter
(ET-ADSER :
DIN 8-pin
sold separately)
(male)
NOTE:
B If the signal cables are disconnected or if the power supply for the
computer or video deck is turned off while "D.ZOOM"(digital zoom) or
"INDEX WINDOW" is being used, these functions will be cancelled.
22-E
NGLISH
signal connector)
R
signal connector)
B
DVD player
(with component
video connectors)
BNC/RCA adapter
DVD player
Video deck
Preparation for the remote control unit
Insert the accessory lithium battery while making sure that the polarities are correct.
# While pushing the battery holder tab to the right, pull out the battery
holder.
Push the tab
$ Insert the battery into the battery holder so that the + side is facing
upward.
% Insert the battery holder.
NOTE:
B Do not drop the remote control unit.
B Keep the remote control unit away from liquids.
B Remove the battery if not using the remote control unit for long periods.
B Use only CR2025 batteries as replacement batteries.
B If the remote control unit is held so that it is facing directly in front of the
remote control signal receptor, the operating range is within
approximately 7 m (23´) from the surfaces of the receptor. Furthermore,
the remote control unit can be operated from an angle of ±30° to the left
or right and ±15° above or below the receptors.
B If there are any obstacles in between the remote control unit and the
receptor, the remote control unit may not operate correctly.
B If strong light is allowed to shine onto the remote control signal receptor,
correct projector operation may not be possible. Place the projector as
far away from light sources as possible.
B If facing the remote control unit toward the screen to operate the projector,
the operating range of the remote control unit will be limited by the amount
of light reflection loss caused by the characteristics of the screen used.
Back side
Pull out
Match the "+"
surface of the
battery with the
"+" marked side of
the battery holder.
E
-23
NGLISH