Panasonic RX-DT670 Manual de Instruções - Página 10

Procurar online ou descarregar pdf Manual de Instruções para Sistema estéreo Panasonic RX-DT670. Panasonic RX-DT670 25 páginas. Portable stereo component system
Também para Panasonic RX-DT670: Manual de Instruções (24 páginas)

Imprimir página

PRECAUTIONS

•If the set Is not used for a long period of time or Is

used only from an AC mains source, remove all the

batteries to prevent potential damage due to possible

battery leakage.

•Avoid using or placing this unit near sources of heat. Do

not leave it in an automobile exposed to direct sunlight for

a long time with the doors and windows closed as this may

deform the cabinet.

•Avoid cuts, scratches, or poor connections in the AC

mains cord, as they may result in possible fire or electric

shock hazard. Also, excessive bending, pulling or splicing

of the cord should be avoided.

•Do not unplug the AC mains cord by pulling on the cord. To

do so may cause premature failure or shock hazard.

•Do not operate the set on AC mains in a bathroom, as a

potential shock hazard may result.

To prevent possible damage to this unit

•Load new batteries with their polarities (® and 0)

aligned correctly.

•Do not apply heat to batteries, or internal short-

circuit may occur.

•If this unit is not to be used for a long period of time,

or used on AC mains supply, remove all batteries

and store them in a cool and dry place.

• Remove spent batteries immediately.

•Do not use old and new batteries together. Also

never use an alkaline battery with a manganese

battery.

•When not in use, disconnect the AC mains cord from the

AC mains outlet.

Operation switch

(OPR/BATT-STDBY (!))

Press to switch the unit from on to standby mode or vice

versa. In standby mode, the unit is still consuming a small

amount of power.

WARNING:

TO REDUCE THE RISK OF FIRE OR ELECTRIC

SHOCK, DO NOT EXPOSE THIS APPLIANCE TO

RAIN OR MOISTURE.

BASIC OPERATING PROCEDURE

■ XBS system (Extra bass system)

When the XBS level control is adjusted, the level of the

dynamic low frequency sound range is boosted.

Using this system with the tone control helps you to get

more dynamic sounds.

■ Graphic equalizer

It allows you to tailor the frequency response of the unit to

compensate for room acoustics and other factors which

affect frequency response. The overall tone can be altered

by adjusting the controls which control the following fre¬

quency bands:

330 Hz, 1 kHz, 3.3 kHz, 10 kHz.

Positioning the control to the

side of the detent will

amplify the corresponding frequency band; the

side will

attenuate it.

■ After use

Be sure to reduce the volume level, and turn off by pressing

the operation switch.

■ Headphones connection

(not included)

•Avoid listening for prolonged periods of time to prevent

hearing damage.

•Speakers are automatically cut off when the headphones

are connected.