Panasonic SA-AK250 Manual de Instruções - Página 16

Procurar online ou descarregar pdf Manual de Instruções para Sistema estéreo Panasonic SA-AK250. Panasonic SA-AK250 20 páginas. Panasonic cd stereo system operating instructions
Também para Panasonic SA-AK250: Manual de Instruções (20 páginas)

Imprimir página

External unit (continued)

Recording from a USB mass

storage class device

Press [4,

desired track for recording.

Press [¶, REC] on the main unit to start recording.

Compatible devices

Devices which are deﬁ ned as USB mass storage class:

• USB devices that support bulk only transfer.

• USB devices that support USB 2.0 full speed.

Supported format

Files must have the extension ".mp3" or ".MP3".

Note:

• CBI (Control/Bulk/Interrupt) is not supported.

• A device using NTFS ﬁ le system is not supported [Only FAT 16/32

(File Allocation Table 16/32) ﬁ le system is supported].

• Depending on the sector size, some ﬁ les may not work.

• This unit can access up to 255 albums (including blank folders)

and 2500 tracks.

• The maximum number of tracks in a folder are 999 tracks.

• Only one memory card will be selected when connecting a

multiport USB card reader. Typically the ﬁ rst memory card

inserted.

• Disconnect the USB card reader from the unit when you remove

the memory card. Failure to do so may cause malfunction to the

device.

• When you connect your digital audio player to the USB port,

it charges all the time except in standby mode or during tape

recording.

RQT8043

/ REW ] or [¢,

/ FF] to select the

Changing the main unit and

EXT-IN

remote control mode

The remote control and main unit are factory-set to

"REMOTE 1" mode.

If your remote control affects other equipment during

operation, you can switch to operate in "REMOTE 2" mode.

To switch to "REMOTE 2" mode

While pressing and holding [EXT-IN] on the main unit

Press and hold [2] until "REMOTE 2" appears on

the main unit display.

Press and hold [ENTER] and [2] for at least 2

seconds.

The main unit and remote control are now set to

operate in "REMOTE 2" mode.

To return to "REMOTE 1" mode

Perform steps 1 and 2 above but use [1] instead of [2] for

both steps. ("REMOTE 1" appears on the main unit during

step 1.)

The remote control cannot work with the main unit if

their modes are different.

"REMOTE 1" or "REMOTE 2" appears on the main unit

display when you operate the remote control.

If "REMOTE 1" appears (The main unit is in "REMOTE 1"

mode.)

Press and hold [ENTER] and [1] on the remote control for

at least 2 seconds.

If "REMOTE 2" appears (The main unit is in "REMOTE 2"

mode.)

Press and hold [ENTER] and [2] on the remote control for

at least 2 seconds.