dibea x500 Manual do utilizador - Página 16

Procurar online ou descarregar pdf Manual do utilizador para Aspirador de pó dibea x500. dibea x500 20 páginas. Smart

Imprimir página

Product Operating

Battery storage and charging

１

Place charging home base

Note: Put charging home base against the wall and remove

obstacles about 1 meter at two sides and about 2 meters forward.

Turn on the Power Switch at the bottom side of the robot,

then display will flash.

(If no command received, the robot will turn to SLEEPING mode after 8 seconds.)

Note: A. Please always keep the power switch turning on. If not, it is unable to make the robot work.

B. If power switch is turned off, all the scheduling will be cancelled.

Caution: Before charge the robot, please make sure the power switch is turned on, or else

the robot can not be charged.

Charge the robot in either way as shown below:

A. Plug into an outlet;

B. Press HOME on main body or on remote control to make robot return to charging home base

for charging itself.

Note:

 A. Turn on the power switch at the bottom side before charge the robot.

B. When robot is charging, display panel will show 1111, and repeat from right to left.

 C. Before first use, charge the robot for 12 hours. When charging is

finished, display panel will show FULL.

 D. In first use, let the robot clean until battery is used up.

E. After battery uses up, recharge the robot as soon as possible.

F. If the robot is not used for long time, please turn the power switch off.

G. When robot is charging, do not make robot start working.

Auto charging

The robot will automatically return to charging home base when cleaning is done or battery is low.

Note: When battery is low, display panel will show "Lo".

Please keep charging home base plugged in. If not, robot is unable to auto charge.

Product Operating

Starting up/Pause/Sleeping

１

Starting up

A. Make sure the power switch is on;

B. Press CLEAN button on main body or on remote control to start cleaning.

Note: If robot is in sleeping mode, press CLEAN button to wake the robot up from sleeping mode.

Then press CLEAN for a second time, the robot starts cleaning automatically.

Pause

To exchange robot from cleaning mode to selected mode:

A. Press either button among PLAN, SPOT, CLEAN and HOME

buttons on main body;

B. Press CLEAN or POWER button on remote control.

Note: When robot is paused, press CLEAN to make robot to re-start cleaning.

Sleeping

To turn robot into sleeping mode from selected mode:

A. Press POWER on remote control;

B. Keep pressing CLEAN on main body for 3 seconds.

Note: If not using the robot for a long time, please turn the power switch off.