EasyPro EFB26 Instruções de instalação

Procurar online ou descarregar pdf Instruções de instalação para Fonte exterior EasyPro EFB26. EasyPro EFB26 2 páginas. Fountain basin

Installation Instructions for Fountain Basins

Thank you for purchasing an EasyPro Fountain Basin. Following are a few simple

instructions to help you during the installation process.

Your basin can be installed in one of two ways, either buried in the ground or above

ground on a deck, patio, etc. Since the majority are installed in the ground (below

grade), these instructions cover that method. If your installation uses the above grade

method you simply need to set the basin on a firm level surface. You can disguise the

basin using timbers, rocks, retaining blocks or a similar

sturdy pieces as desired.

STEP ONE

Bury the basin to your desired depth. It can be totally or

partially buried depending on your desired effect. Dig the

hole slightly larger than the basin allowing some room

for adjustment. Be sure the soil under the basin is firm

If installing an autofill valve, do so at this point. An autofill, such as the EasyPro BFS or

WFS37, can be mounted on any of the four walls. Install approximately 2" below the top

lip of the basin on the wall that is most convenient for your plumbing.

STEP FOUR

If excessively heavy statuary is being used additional support between the grating and

basin floor may be needed.

The 50" basin includes two pieces of deck grating to lay on top of the basin. One of the

pieces has an access door cut in the corner. Since the basin is square you can install the

grating in any orientation.

The 26" basin has a one piece grate that also has an access door in one corner and can

be installed in any direction in the basin.

Before installing grating on 26" basin ... Install the two pieces of aluminum angle into

the two sockets on opposing walls of the basin. Position the angle upside down - this

creates an upside down "V" shape for maximum strength.

STEP FIVE

Your basin also includes a section of

grating and prevents small rocks, twigs, etc. from getting into the basin.

After placing the mesh on the grating, cut a 1" hole in the mesh in the location of your

statuary piece. This allows the tubing from the statuary through the mesh down into the pump area.

and compact.

STEP TWO

Set the basin into the hole making sure it is installed level in

both directions then back fill around it.

STEP THREE (OPTIONAL)

" black plastic mesh. This mesh lays over the