EasyPro Cabrio Lighting Series Instruções de utilização, segurança, garantia - Página 2
Procurar online ou descarregar pdf Instruções de utilização, segurança, garantia para Equipamento de iluminação EasyPro Cabrio Lighting Series. EasyPro Cabrio Lighting Series 4 páginas. Color changing led light
Installation of LED Light (continued)
4. Use with or without removable base to fit fixture into desired location. If
base is used it may need to be ballasted to prevent fixture from shifting.
5. Run wire from LED fixture back towards control module and power source.
6. Join the light to the control module by connecting
the 4-prong quick plug, tighten the retention ring to
ensure a secure connection. (Figure 1) Do not sub -
merge connection or control module.
7. Join the control module to the transformer by
connecting the 2-prong quick plug and tighten the
retention ring. (Figure 2)
Note: Power supply must be maintained to control
module or light will default back to mode 1 on start -
up (transformers with automatic operation will reset
the control module back to default on each start
due to power interruption.)
8. Plug the transformer into a GFCI outlet.
9. The LED light will default to mode 1 on initial startup. Use CLEDRC remote
to sync multiple Cabrio fixtures together, change modes, brightness and
speed.
Remote Control Operation
•
A single remote can operate multiple Cabrio fixtures in any combination
within its range.
Depress mode, brightness and speed buttons slowly and deliberately to
•
ensure all light fixtures remain in sync on the same cycle.
•
Desired setting must be achieved by clicking remote functions, holding a
button down will not change settings.
•
CLEDRC remote requires an A23 battery (included).
Power on/off
Slower Speed
Lower Brightness
Change Mode Backwards
Red (mode 21)
Blue (mode 23)
(remote control sold separately)
Figure 1
Figure 2
Reset Defaults (mode 1)
Faster Speed
Raise Brightness
Change Mode Forwards
Green (mode 22)
White (mode 27)
A23 battery included