Alpha Fan AX80-5B/46 Manual de instruções - Página 3
Procurar online ou descarregar pdf Manual de instruções para Ventilador Alpha Fan AX80-5B/46. Alpha Fan AX80-5B/46 8 páginas.
Imprimir página
SAFETY PRECAUTION
CAUTION
Please take note of the following important points when installing.
The fixing means for attachment to the ceiling such as hooks or other devices shall be fixed with a
sufficient strength to withstand 4 times the weight of the ceiling fan.
The mounting of the suspension system shall be performed by the manufacturer, its service agent
or suitably qualified persons.
The fan is to be installed so that the blades are more than 2.5m above the floor.
Safety cord should not be longer than the earthing conductor.
Should failure of the suspension system occur, the supporting of the fan must not rely on the
earthing conductor. The earthing terminal in the fan assembly should be such that should any part
of the suspension system fall off, the body of the fan assembly shall effectively earthed.
Ensure that the unit's panel is closed after service or installation.
Unsecured panels will cause the unit to operate noisily.
Sharp edges and coil surfaces are potential locations which may cause injury hazards.
Avoid from being in contact with these places.
Before turning off the power supply set the remote controller's ON/OFF switch to the "OFF"
position.
If this is not done, the unit's fans will start turning automatically when power resumes, posing a
hazard to service personnel or the user.
Do not operate any heating apparatus too close to the ceiling fan unit or use in room where mineral
oil, oil vapour or oil steam exist, this may cause plastic part to melt or deform as a result of exces-
sive heat or chemical reaction.
Avoid the ceiling fan unit from exposing to direct sunlight, this may cause degradation of plastic
material as a result of excessive heat and UV radiation.
Ensure the colour of wires of the outdoor unit and the terminal markings are same to the indoors
respectively.
Do not use joined and twisted wires for incoming power supply.
Do not place any object in the path of the blades. Avoid raising objects or your arms near the ceiling
fan.
The fan suspension system and blade screw tightening shall be examined yearly.
Replacement of parts of the safety suspension system device shall be performed by the manufac-
turer, its service agent or suitably qualified persons.
Torque value for screw/bolts for securing primary suspension system for motor is 2Nm.
2
Motor Assembly with Downrod,
Coupling Cover and Canopy
8
7
1
6
2
5
3
4
Rubber Pulley Assembly
Blade
Screw
Transmitter &
Holder x 1
3
AX80-3B/56 : Fan Blade x 3
AX80-5B/40 : Fan Blade x 5
AX80-5B/46 : Fan Blade x 5
AX80-5B/56 : Fan Blade x 5
Switch Housing
Receiver
Battery x 2
AAA
AAA
Wall Screw x 2