EPC 611 Como começar - Página 2

Procurar online ou descarregar pdf Como começar para Placa-mãe EPC 611. EPC 611 15 páginas. Evaluation kit

Ihr autorisierter Distributor

Eye safety: Do not look directly into the camera under operation. Depending on the mode of operation, the camera device

emits highly concentrated non-visible infrared light. It can be hazardous to the human eye. The use of these devices has

to follow the safety precautions given in IEC 60825-1 and IEC62471.

Some of the camera modules are bare electronic devices without a housing surround. Therefore, handle them with the necessary

ESD precaution.

Over-voltage: Use only power supplies which correspond to the datasheet of the cameras to avoid damage of the devices or

cause danger for humans.

Cable-tripping: Place the sensors on solid ground or fix it correctly on a solid support. Place cables carefully. Falling devices can

be damaged.

The sensors comes with their own calibrated firmware. For proper operation of the sensors, upload the correct firmware with the

evaluation kit to the sensors according the instructions given herein.

Take care that the lens surfaces of the cameras do not get soiled. Do not touch them. Otherwise loss of performance occurs.

EMC compatibility: The epc611 Evaluation Kit is designed on module level. It is not an EMC certified device. It is the responsibility

of the user to operate it in compliance with the EMC regulations.

The epc611 Evaluation Kit is designed on module level. It is NOT a CE, UL, CSA certified device. It is the users responsibility to

operate it in compliance with the relevant regulations.

The cameras of the epc611 Evaluation Kit and their software may only be be used in accordance with the information contained in

their datasheets.

These devices may not be used in safety applications, explosive atmospheres or in radioactive environment.

Limited warranty - Loss of warranty

The epc611 Evaluation Kit should only be installed and used by authorized persons. All instructions in this datasheet and in the re-

lated documents shall be followed and fully complied with. In addition, the installer and user is required to comply with all local

laws and regulations. Should any of these instructions not be carefully followed, serious injury may occur. The installer and user is

fully responsible for the safe use and operation of the system. It is the sole responsibility of the installer and the user to ensure that

this product is used according to all applicable codes and standards, in order to ensure safe operation of the whole application.

Any alteration to the devices by the buyer, installer or user may result in unsafe operating conditions. ESPROS Photonics AG is

not responsible for any liability or warranty claim which results from such manipulation or disregarding of given operating instruc -

tions.

ESPROS Photonics is constantly striving to provide comprehensive and correct product information. Therefore, please check

our website regularly for updated versions of datasheets and documentations: www.espros.com

Download the current Datasheet epc611: www.espros.com → Downloads → Datasheets → Chips

Download the current Datasheet TOF>range 611 or TOF>frame 611: www.espros.com → Downloads → Datasheets →

Camera_and_Modules

Download the current Manual epc611_Evalkit: www.espros.com → Downloads → Datasheets → Evaluation_Kits

Always download and use the latest epc611 Evaluation Kit software.

Questions: Send an email with your request to your local sales office or to [email protected]

Update the epc611 Evaluation Kit software : Go to the folder "ESPROS_epc611_Evaluation_Kit_Software_vX.X". Read the

Readme file and follow the instructions accordingly.

Characteristics subject to change without notice

Neumüller Elektronik GmbH

1. Precaution and Safety

UPDATES

2 / 15

Manual_epc611_Evalkit-V1.01