EPC NEO 10A Manual - Página 5

Procurar online ou descarregar pdf Manual para Carregador de bateria EPC NEO 10A. EPC NEO 10A 13 páginas.

Page 5 of 13

Intended use

 The intended use of the NEO battery chargers are recharging of rechargeable batteries

only. Batteries must be of the type Lead/Acid Open/GEL/AGM/, capacity range 20 – 100

Ah. The appliance is used for charging electrically powered wheelchairs and scooters.

 Place the charger on a level surface.

 Place the charger out of reach of children and in such a manner that the cables do not

obstruct or cause inconvenience to passers-by.

 Do not place objects on the charger and avoid covering the device in any other way.

When installed near a window, the charger must be protected against direct sunlight, as

this will contribute to heating the charger, prolonging the charging time.

 The mains cable has to be accessible during charging enabling the user to disconnect the

charger form the supply mains at any time during charging.

 Keep the charger clean and free from dust. Contact your dealer for instructions on how

to clean your charger in case of severe soiling. The charger should be cleaned using only

a dry cloth. Do not open the charger.

 As a precaution you should always ask your supplier to make preventive inspection of the

charger whenever the wheelchair is in for service or maintenance. Such inspection is only

to be performed by authorized personnel.

 Use the correct mains voltage and frequency.

 The charger is for indoor use only.

Gas: Explosive gasses – avoid flames and sparks. Acid: The acid in the battery is

corrosive. In case of spills, wash and rinse with plenty of water. Acid in the eyes

may harm the eyes, rinse with water and seek medical attention. Poison: Lead and

chemicals used in batteries are toxic. Wash hands and skin thoroughly after working

with batteries.

Accessories

 The matching smartphone app can be downloaded via Google Play.

Follow these steps to use the charger:

 When the charger is connected to the mains, the green LED will light; the charger is now

ready for use.

 Before connecting the charger to the battery, check that the battery is of the same type

as specified on the rating plate on the back of the charger. Do not, under any

conditions, connect the charger to non-rechargeable batteries.

 The charging process starts automatically when the charger is connected to the battery

and the yellow LED starts flashing.

 Once the battery is 100 % recharged, the yellow LED will light permanently. This means

that the charger can be disconnected.

W a r n i n g !