Alpha Microsystems AM-402 Manual de instruções de instalação - Página 10
Procurar online ou descarregar pdf Manual de instruções de instalação para Equipamento de gravação Alpha Microsystems AM-402. Alpha Microsystems AM-402 17 páginas. Scsi cd-recorder
Imprimir páginaPage 3
/TOC
/TEST
/TESTFIRST
/VERBOSE
MAKACD with no switches will create an ACD compatible CD, using the CDR: device found
by scanning the SCSI bus. The CD will be created using the maximum recording speed of the
CD-Recorder, without first doing a test copy.
OPERATION
Before starting the program, place a blank CD or partially recorded CD in the CD-recorder.
Recording on a partially recorded media will render all previously recorded information
inaccessible.
It is recommended that the system be idle. Other users or system activity could interfere
with CD recording and cause the CD to be unusable. Once recording has started, the CD-
recorder must receive a constant stream of data until the entire recording is finished. If
the CD-recorder runs out of data before recording is finished, the program will abort with
a fatal error.
Copying logical disks to the CD-recorder that are being updated by other users can result
in CDs containing incorrect or incomplete data.
Type MAKACD from the AMOS prompt:
MAKACD
MAKACD will attempt to find a CD-recorder that is compatible with the CD-recorder driver
being used. The driver must have the same name as the CD-recorder device name and either be
loaded in system memory or reside in DSK0:[1,6]. MAKACD will find the CD-recorder either
using the command line switches /DEV and /ID or by defaulting to CDR: if /DEV is not
specified and by scanning the SCSI bus if /ID is not specified. If more than one CD type device
is found when scanning the SCSI bus, you will be asked to choose the device you wish to use for
recording.
Scanning the SCSI bus will find CDROM devices as well as CD-recording devices.
System Commands Reference Manual, Rev. 11
Speeds from 1 to 32 may be specified. If the CD-Recorder does
not support the speed specified, recording will be done at a lower
supported speed.
Writes the table of contents of the current CD and exits.
Write CD in test mode, which does everything except turn the
CD laser on when recording.
Does a TEST first, followed by the actual CD recording if no
errors were encountered in the TEST.
Display additional error messages.
RETURN
MAKACD