EPH Controls RFRP-OT Instruções de utilização
Procurar online ou descarregar pdf Instruções de utilização para Termostato EPH Controls RFRP-OT. EPH Controls RFRP-OT 4 páginas. Wireless room thermostat
Imprimir página
RFRP-OT Room Thermostat
RFRP-OT Room Thermostat
Contents
1.
Factory default settings
2.
Speci cations
3.
Mounting
4.
Installation
5.
Frost protection
6.
LCD symbol / buttons description
7.
Resetting the thermostat
8.
Keypad lock and unlock
9.
Setting the date, time and operating mode
10. Factory program settings
11. Adjusting the program settings for 5/2d
12. Copy Function
13. Temporary override
14. Permanent override
15. Boost function
16. Holiday function
17. To connect the RFRP-OT thermostat to an RF1A-OT receiver
18. To disconnect the RFRP-OT thermostat from an RF1A-OT receiver
19. Backlight mode selection
20. Battery low warning
21. Replacing the batteries
22. Installer Menu (without OpenTherm® connected)
How your programmable thermostat works
When the thermostat is in the AUTO mode, it will operate according to the
times and temperatures that have been programmed. The user can select
from 6 di erent programs per day - each with a time and a temperature.
There is no OFF time, only a higher and a lower temperature.
If the user wants the thermostat to be OFF at a certain time, set the
temperature for this time to be low. The thermostat will turn ON if the room
temperature is lower than the setpoint for the current period.
Example: If P1 is set to be 21˚C at 6am, and if P2 is set to be 10˚C at 8am, the
thermostat will look for the temperature to be 21˚C between 6am and 8am.
1. Factory default settings
Temperature indicator:
Switching di erential:
In built frost protection:
Clock:
Keypad lock:
Operating mode:
2. Speci cations
Power supply:
Power consumption:
Battery replacement:
Temp. control range:
Ambient temperature:
Dimensions:
Temperature sensor:
Temperature indication:
Switching di erential:
Frost protection:
Pollution degree:
°C
0.4°C
5°C - Not adjustable
24 hours
O
5/2 day
2 x AA Alkaline Battery
2 mW
Once a year
5 ... 35°C
0 ... 45°C
130 x 99 x 25mm
NTC 100K Ohm @ 25°C
˚C
0.4˚C
Only operational in OFF mode
Pollution degree 2
EPH Controls Ireland
[email protected] www.ephcontrols.com
Boiler
Plus
Wireless
Wireless
3. Mounting
The mounting height should be 1.5 metres above the oor level.
The thermostat should be wall mounted in the room where the heating is to
be controlled.
The place of installation should be chosen so that the sensor can measure the
room temperature as accurately as possible.
Choose the mounting location to prevent direct exposure to sunlight or other
heating / cooling sources when mounted.
The unit can be tted to:
1. Directly on walls.
2. Table mounting with stand provided.
4. Installation
Lower the ap at the front of the thermostat.
There is a battery compartment located below the buttons.
Apply downward pressure to remove the cover.
Insert the 2 x AA batteries and the thermostat will turn on.
Close the battery compartment.
5. Frost protection
Frost protection is built into this thermostat.
It is pre xed at 5°C and is not adjustable.
It will only be activated when the thermostat is in the OFF mode and the
room temperature falls below 5°C.
6. LCD Symbol / button description
6.1 LCD Symbol description
Current program
Day / Month
Current Time
(Boost to time)
EPH Controls UK
[email protected] www.ephcontrols.co.uk
Page 1 of 4
Operating Instructions
CAUTION!
The thermostat must not be left unsupervised
when open. (Prevent non specialists and especially
children from gaining access to it.)
Only quali ed electricians or authorised service
sta are permitted to open the thermostat.
If the thermostat is used in a way not speci ed by
the manufacturer, its safety may be impaired.
Important: Keep this document
Prior to setting the thermostat, it is neccessary to
complete all required settings described in this section.
5°C
Temperature
Day of the week
Operating mode
20190627_RFRP-OT_OpIns_JW
Battery low symbol
Wireless symbol
Heating on symbol
Keypad lock symbol