DieHard 200.71224 Manual do Proprietário - Página 11
Procurar online ou descarregar pdf Manual do Proprietário para Carregador de bateria DieHard 200.71224. DieHard 200.71224 17 páginas. Battery charger 15/2 amp fully automatic microprocessor controlled engine starter 100 amp
Também para DieHard 200.71224: Manual do Proprietário (16 páginas)
Imprimir página
Charging your battery removed from
the vehicle:
PosrrlvE
NEGATIVE
'CHARGER
POWER
CORD
24",6 GAUGE
CABLE
TO
GROUNDED
POWER
OUTLET
1. Note the polarity of the battery posts
by checking the identification
marks
on the battery: POSITIVE (POS, P or
+) and NEGATIVE (NEG, N or -). The
positive post is usually larger than
the negative post.
2. Attach
at least a 24-inch-long
6-
gauge
(AWG)
insulated
battery
cable
to NEGATIVE
(NEG,
N or-)
battery
post. Rock and twist the clamp
back
and forth to be sure a solid electrical
connection
is made.
3. Connect the red (POSITIVE) output
clamp to the POSITIVE battery post.
Rock and twist the clamp back and
forth to be sure a solid electrical
connection is made.
4. Position
yourself as far away from
the battery
as possible,
and then
connect
the black
(NEGATIVE)
output clamp to the free end of the
cable.
5. Plug the power cord into an AC
outlet. The charger will set to the
default state of 2 AMP charge rate
and Type 1 for battery type.
6. Press the appropriate
control
buttons
to select
the desired
charge
rate and
battery
type. Within
a few seconds,
the red LED should
go out and the
charging
process
should
start. If the
red LED does not go out, check
for
correct
cable connection.
.
.
To disconnect the charger, unplug
the charger power cord before
attempting to disconnect the charger
clamps. Then, standing away from
the battery, remove the output clamp
from the NEGATIVE battery post.
Finally, remove the output clamp
from the POSITIVE battery post.
Clean and store the charger in a dry
location.
USING ENGINE START
Your battery charger can be used to
jump start your car if the battery is low.
Follow these instructions on how to use
the ENGINE START feature.
IMPORTANT:
Follow all safety
instruc-
tions and precautions
when charging
your battery. Wear complete
eye
protection and clothing protection.
Charge your battery in a well-ventilated
area.
IMPORTANT:
Using the ENGINE
START feature WITHOUT a battery
installed in the vehicle could cause
damage to the vehicle's electrical
system.
1. With the charger plugged in and
connected to the battery of the
vehicle, press the 100 AMP touch
pad. Only the 100 AMP indicator
lamp should be lit.
,
.
.
Crank the engine for no more than 3
seconds. If engine does not start, let
rest for 4 minutes before cranking
again.
After the engine starts, unplug the
power cord before
disconnecting
the
output
clamps
from the battery.
Clean
and store the charger
in a dry
location.
11