EPH Controls RF1A-OT Instruções de utilização - Página 2
Procurar online ou descarregar pdf Instruções de utilização para Recetor EPH Controls RF1A-OT. EPH Controls RF1A-OT 2 páginas. With rfrp-ot
Também para EPH Controls RF1A-OT: Instruções de utilização (2 páginas)
Imprimir página
RF1A-OT - Wireless Receiver
5. Resetting the RF1A-OT receiver
Press the
button located on the side of the receiver. The RF1A-OT
RESET
receiver is now reset.
6. To connect the RFRP-OT thermostat to an RF1A-OT
receiver
Please note, If you are installing a CombiPack4 the RFRP-OT thermostat and
the RF1A-OT receiver will have a pre-established RF connection so it is not
necessary to carry out the RF connection process below.
On the RF1A-OT receiver:
Press the
button on the RF1A-OT receiver.
Connect
The red light will begin to ash.
On the RFRP-OT thermostat:
Press the
button.
Connect
The thermostat will show "nOE" followed by "---"
Once an RF connection has been established the thermostat will show 'r01'
on the LCD screen.
Press the 'OK' button to nish the process.
The thermostat is now connected to the RF1A-OT receiver.
7. To disconnect the RFRP-OT thermostat from an
RF1A-OT receiver
This can be done from either the thermostat or the receiver.
7.1 On the RFRP-OT thermostat:
Press the
button.
Connect
The thermostat will begin to search through the RF channels.
Press and hold the 'Copy' button for 10 seconds.
'Adr' will appear on the screen of the thermostat.
Press the 'OK' button twice to complete the unpairing process.
The thermostat RFRP-OT is now disconnected from the receiver RF1A-OT.
7.2 On the RF1A-OT receiver:
Press the
button, the red light will ash.
Connect
Red & green lights if using as a hub receiver.
Press and hold connect for about 10 seconds, the receiver will then stop ashing.
The RF connection is now cleared.
EPH Controls Ireland
[email protected] www.ephcontrols.com
with RFRP-OT
EPH Controls UK
[email protected] www.ephcontrols.co.uk
Page 2 of 2
Operating Instructions
20190430_RF1A-OT-RFRP-OT_OpIns_JW