DieHard 2871222 Manual do operador - Página 8
Procurar online ou descarregar pdf Manual do operador para Carregador de bateria DieHard 2871222. DieHard 2871222 13 páginas. 12v battery charger & engine starter
Também para DieHard 2871222: Manual do operador (13 páginas)
Imprimir página
11. OPERATING INSTRUCTIONS
NOTE: The charger does not have an ON/OFF switch. The ON and OFF commands are
controlled by plugging the 71222 into a 120V AC electrical wall outlet only after the battery
connections have been made.
Charging
1. Make sure to place the charger on a dry, non-flammable surface, such as metal
or concrete.
2. Ensure that all of the charger components are in place and in good working condition,
including the plastic boots on the battery clips.
3. Connect the battery, following the precautions listed in sections 6 and 7.
4. Select the appropriate settings for your battery.
5. Connect the AC power, following the precautions listed in section 8.
6. To disconnect the charger, reverse the above procedures.
Automatic Operation
When an automatic charge is performed, the charger switches to a maintain mode
automatically after the battery is charged.
Aborted Charge
If charging cannot be completed normally, charging will abort. When charging aborts, the
charger's output is shut off and the LED will blink (two blinks followed by a pause). All
charger function switches become non-functional. To reset after an aborted charge, unplug
the charger from the AC outlet, wait a few moments and plug it back in.
Completion of Charge
Charge completion is indicated by the LED. When lit steadily, the charger has switched to
the Maintain Mode of operation.
Maintain Mode (Float-Mode Monitoring)
When the LED is lit, the charger has started Maintain Mode. In this mode, the charger
keeps the battery fully charged by delivering a small current when necessary.
NOTE: If the charger has to provide its maximum Maintain Mode current for a continuous
12 hour period, it will go into Abort Mode (see Aborted Charge section). This is usually
caused by a drain on the battery or a bad battery. Make sure there are no loads on the
battery. If there are, remove them. If there are none, have the battery checked or replaced.
Maintaining a Battery (2 amp charge rate)
The charger maintenance setting will keep 12 volt batteries at full charge. The setting can
also be used to charge smaller batteries. However, if you use the setting to charge a large
battery, such as a marine deep-cycle battery, battery capacity may be lost. The battery
would then be unable to hold a charge and become useless. Avoid using the maintenance
setting to charge a large battery.
NOTE: The maintain mode technology utilized in DieHard chargers allows you to safely
charge and maintain a healthy battery for extended periods of time. However, problems
with the battery, electrical problems in the vehicle, improper connections or other
unanticipated conditions could cause excessive current draws. As such, occasionally
monitoring your battery and the charging process is recommended.
This battery charger must be properly assembled in accordance with the
assembly instructions before it is used.
8
•
•