DieHard 751317212 Manual do operador - Página 5

Procurar online ou descarregar pdf Manual do operador para Arrancador remoto DieHard 751317212. DieHard 751317212 13 páginas. 12v battery charger & engine starter

Imprimir página

1. Features /Control Panel

3.5 Read, understand and follow all instructions for the charger, battery, vehicle and any

equipment used near the battery and charger. Study all of the battery manufacturer's

specific precautions while charging and recommended rates of charge.

3.6 Determine the voltage of the battery by referring to the vehicle owner's manual and make

sure that the output voltage is correct for your battery.

3.7 Make sure that the charger cable clips make tight connections.

4. CHARGER LOCATION

battery being charged; gases from the battery will corrode and damage the charger.

4.3 Do not set the battery on top of the charger.

4.4 Never allow battery acid to drip onto the charger when reading the electrolyte specific

gravity or filling the battery.

4.5 Do not operate the charger in a closed-in area or restrict the ventilation in any way.

5. DC CONNECTION PRECAUTIONS

5.1 Connect and disconnect the DC output clips only after removing the AC plug from the

electrical outlet. Never allow the clips to touch each other.

5.2 Attach the clips to the battery and chassis, as indicated in sections 6 and 7.

6. FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED IN VEHICLE

hood during the charging process, ensure that the hood does not touch the metal part of

the battery clips or cut the insulation of the cables.

6.2 Stay clear of fan blades, belts, pulleys and other parts that can cause injury.

6.3 Check the polarity of the battery posts. The POSITIVE (POS, P, +) battery post usually has

a larger diameter than the NEGATIVE (NEG, N, -) post.

6.4 Determine which post of the battery is grounded (connected) to the chassis (vehicle

frame). If the negative post is grounded to the chassis (as in most vehicles), see step 6.5.

If the positive post is grounded to the chassis, see step 6.6.

6.5 For a negative-grounded vehicle, connect the POSITIVE

(RED) clip from the battery charger to the POSITIVE

(POS, P, +) ungrounded post of the battery. Connect the

NEGATIVE (BLACK) clip to the vehicle frame or engine

block at a distance away from the battery. Do not connect

the clip to the carburetor, fuel lines or sheet-metal body

parts. Connect to a heavy gauge metal part of the vehicle

frame or engine block.

RISK OF EXPLOSION AND CONTACT WITH

BATTERY ACID.

4.1 Locate the charger as far away from the

battery as the DC cables permit.

4.2 Never place the charger directly above the

A SPARK NEAR THE BATTERY MAY CAUSE A

BATTERY EXPLOSION. TO REDUCE THE RISK

OF A SPARK NEAR THE BATTERY:

6.1 Position the AC and DC cables to reduce the

risk of damage by the hood, door and moving or hot

engine parts. NOTE: If it is necessary to close the

•

NEGATIVE GROUNDED SYSTEM