DieHard Portable Power 950 Manual do operador - Página 12
Procurar online ou descarregar pdf Manual do operador para Carregador de bateria para automóvel DieHard Portable Power 950. DieHard Portable Power 950 13 páginas. 12v dc power source and jump starter
Também para DieHard Portable Power 950: Manual do operador (9 páginas), Manual do operador (9 páginas), Manual do Proprietário (9 páginas), Manual do operador (7 páginas)
Imprimir página
10.5
IMPORTANT:
•
CHARgE IMMEDIATELY AfTER PURCHASE
•
KEEP fULLY CHARgED
Charge the jump starter internal battery immediately after purchase, after
every use and every 30 days.
All batteries are affected by temperature. The ideal storage temperature is
at 70 degrees Fahrenheit. The internal battery will gradually self-discharge
(lose power) over time, especially in warm environments. Leaving the battery
in a discharged state may result in permanent battery damage. To ensure
satisfactory performance and avoid permanent damage, charge the internal
battery every month.
11.
TROUBLESHOOTINg
PROBLEM
The jump starter won't jump
start my car.
The jump starter won't
power my 12v device.
The battery in the jump
starter won't hold a charge.
The jump starter alarm is
on.
POSSIBLE CAUSE
Jump Start On/Off switch is
not turned ON.
Clips are not making a good
connection to the battery.
The jump starter battery is
not charged.
The vehicle's battery is
defective.
The 12v device is not
turned on.
The jump starter battery is
not charged.
The 12v device draws more
than 15A or has a short
circuit
The battery is bad (will not
accept a charge).
Connections are reversed.
9
•
•
REASON/SOLUTION
Turn ON the Jump Start On/
Off switch.
Check for poor connection
to battery and frame. Make
sure connection points
are clean. Rock the clips
back and forth for a better
connection.
Check the battery charge
status by pressing the
button on the front of the
jump starter. See dIgITAL
dISPLAY FUNCTIONS
section of this manual.
Have the battery checked.
Turn on the 12v device.
Check the battery charge
status by pressing the
button on the front of the
jump starter. See dIgITAL
dISPLAY FUNCTIONS
section of this manual.
disconnect the 12v device.
The internal breaker will
automatically reset after a
minute or two. Try the 12v
device again. If it happens
again, replace the 12v
device.
Have the battery checked.
disconnect the jump starter
and reverse the clips.