Olympus BH2 Series Desmontagem, limpeza e remontagem - Página 24
Procurar online ou descarregar pdf Desmontagem, limpeza e remontagem para Microscópio Olympus BH2 Series. Olympus BH2 Series 45 páginas. Phase contrast
Também para Olympus BH2 Series: Manual de resolução de problemas e ajuste (46 páginas), Desmontagem, limpeza e remontagem completas (23 páginas), Desmontagem, limpeza e remontagem completas (40 páginas), Manual (6 páginas), Manual de instalação (9 páginas)
Imprimir página
Beneath the diaphragm rotor, there are 10 diaphragm
leaves positioned within the circular recess of the metal
diaphragm stator. See
Figure
Figure 85 – Diaphragm leaves in the metal stator
Remove the 10 diaphragm leaves from the metal
diaphragm stator by carefully lifting the individual
leaves such that the pivot pins come free of the pivot
holes in the stator. See
Figure 86 – Carefully remove the diaphragm leaves
Clean Components of Field Diaphragm Assembly (Old Style)
Using a suitable solvent, such as acetone, thoroughly
clean the metal diaphragm stator. See
Figure 87 – Thoroughly clean the diaphragm stator
Teardown, Cleaning, and Reassembly of the Miscellaneous Parts of the Olympus BH-2 Microscope Frames
85.
Figure
86.
Figure
87.
Using a suitable solvent, thoroughly clean the
diaphragm leaves. See
metal, acetone may be used to clean them. If the
leaves are plastic, do not use acetone, but instead, use a
plastic-safe solvent, such as alcohol.
Figure 88 – Thoroughly clean the diaphragm leaves
Using a suitable solvent, thoroughly clean the
diaphragm rotor (see
Figure
acetone may be used to clean it. If the rotor is plastic,
do not use acetone, but instead, use a plastic-safe
solvent, such as alcohol.
Figure 89 – Thoroughly clean the field diaphragm rotor
Reassemble the Field Diaphragm Assembly (Old Style)
Exercise caution when handling the diaphragm leaves
during reassembly, as any oil or contamination on the
leaves can impair proper operation of the iris
mechanism. When reinstalling the diaphragm leaves
into the metal diaphragm stator, it is important that the
pivot pin at the end of the leaves with relief notches (if
present) are placed into the holes in the metal
diaphragm stator (See
Figure 90
on the opposite ends of the leaves. These recesses
provide clearance to prevent the leaves from interfering
with adjacent leaves. Note that the leaves in some
Figure
88. If the leaves are
89). If the rotor is metal,
inset), and not the pins
Revision 1
Page 24 of 45