Olympus BX43 Manual de instruções - Página 22

Procurar online ou descarregar pdf Manual de instruções para Microscópio Olympus BX43. Olympus BX43 48 páginas. System microscope

5-3 Stage

Fig. 24

Fig. 25

Fig. 26

Placing the Specimen

} The dimensions of the slide glass should be 26 x 76 mm with thickness of

0.9 to 1.2 mm, and the cover glass should have thickness of 0.17 mm.

} When observing very large specimens, remove the slide holder and place

the specimen directly on the stage.

Microscopy with Double-Slide Holder (Fig. 24)

1. Turn the coarse adjustment knob @ to lower the stage.

2. Open the spring-loaded curved finger 2 on the slide holder and place

one or two specimen slides on the stage from the front.

3. After placing the sides as far as they will go, gently release the curved

finger.

Microscopy with Single-Slide Holder (Fig. 25)

The specimen side can easily be placed by sliding it into the slide holder

from the front.

Examining a whole specimen

Use one of the thin slide holders listed below that cause less interference

with the objectives*.

· U-HRD-4

· U-HLD-4

* The applicable objectives are ones with 40X or less magnification (except

Apo series).

Using an Oil Immersion Condenser

Use the optional U-SVRO (right-hand knob) or USVLO (left-hand knob)

slotted stage which prevents close contact between the specimen and

stage.

Using the Auxiliary Slide Holder

Applicable revolving nosepieces: U-D7RE, U-D7RES, U-P6RE,

U-D6BDRE, U-P5BDRE

} When a biological slide glass specimen is placed on the U-HLDT4/U-

HRDT4 two-slide holder (thick type), the slide holder may interfere with

the objective when the following conditions are combined;

· The objective in use has a short WD (Working Distance);

· The sspecimen being observed is the specimen placed on the rear

side of the side holder, and;

· The stage is in a rotated position.

If the slide holder contacts the objective, set the provided auxiliary slide

holder @ as shown in the figure and observe only the specimen on the

front side of the slide holder.

· U-HLS-4