Olympus BX60 Manual de instruções - Página 2

Procurar online ou descarregar pdf Manual de instruções para Microscópio Olympus BX60. Olympus BX60 48 páginas. System microscope
Também para Olympus BX60: Manual de início rápido (4 páginas)

Imprimir página

BX60

IMPORTANT

This unit employs the UIS (universal infinit system) optical design and should be used only with UIS

eyepieces, objectives, and condensers. Less than optimum performance may result if inappropriate

accessories are used.

BX6O is a versatile microscope which can be used both with transmitted light for use in the biological

field and with reflected light for metallurgical research.

Accordingly, this instruction manual contains:

• Separate outlines of the observation procedures when the microscope is used in biological or

metallurgical research purposes.

• Explanation of the use of controls is divided into sections.

• The most important points of the various observation methods are explained.

For reflected light fluorescence microscopy also refer to the manual pertaining to the reflected

light fluorescence attachment BX-fLA.

Getting Ready

1. A microscope is a precision instrument. Handle it with care and avoid

subjecting it to sudden or severe impact

2. The 8X60 series can be used with any kind of one additional inter

mediate tube excluding U-DO dual-viewing attachment and U-MDO10

multi-viewing attachment.

3. Do not use the microscope where the following conditions exist: direct

sunlight high temperature and humidity, dust or vibrations. (Working

environment ambient temperature and hunrmfity should be in the range

of 0-40°C. 30-90%.)

4. When moving the microscope, carefully cany it with both hands by

grasping the arm as shown in the figure on the left-

* You can damage the microscope if It it lifted from the ttage.

coarse adjustment knob, or lamp housing.

5. Set the voltage selector switch on the rear of the base to the 100 -120V

or 220-240V position to match the local line voltage, using a flat-head

screwdriver. (Before shipment from the factory, the voltage selector

switch is set to 220-240V position). (See figure on the left)

6. To avoid potential shock hazard, be sure to properly ground the power

cord.

7. Always turn OFF the main switch and disconnect the power coed before

replacing the halogen bulb or fuses.