Olympus SZX10 Manual de instruções - Página 24
Procurar online ou descarregar pdf Manual de instruções para Microscópio Olympus SZX10. Olympus SZX10 40 páginas. Research high-class stereo microscope
Também para Olympus SZX10: Visão geral (24 páginas), Manual de instruções (36 páginas)
Imprimir página
8-2 Detailed Assembly Procedure
c
30° or less
20
Downloaded from
ManualsNet.com
b
a
b
a
c
search engine
1
Installing the Pillar
1
Using the Allen wrench provided with the base, loosen the two
clamping screws a on the pillar support sleeve completely.
2
Hold the pillar b so that the Allen screwdriver storage hole made
of white rubber comes at the top, and insert the pillar into the pillar
support sleeve until it reaches the bottom.
3
Tighten the two clamping screws a securely using the Allan wrench.
Reserve Screw Holes
Two screw holes c (6 mm) are provided for use in mounting a
manipulator, etc.
2
Mounting the Focusing Assembly
1
First loosen the focusing assembly clamping knob a completely
and, while holding the focusing assembly with both hands, insert the
pillar c into the mounting hole b from below.
Insert vertically and slowly. Do not apply excessive force.
NOTE
2
Lower the focusing assembly until it stops, then tighten the focusing
assembly clamping knob a .
To prevent the microscope from turning over, the focusing
CAUTION
assembly must be installed on the same side as the
stage plate in the stand, as shown in the illustration
marked " " in figure, and its pivot angle must be limited
to 30°. If the focusing assembly is placed on the wrong
side, the microscope will turn over.
If the clamping knob a is tightened while the pillar c
NOTE
is not completely inserted into the mounting hole b , the
plate spring supporting the pillar will deform and the pillar
will not be able to penetrate into the hole.