Olympus SZX10 Manual de instruções - Página 28

Procurar online ou descarregar pdf Manual de instruções para Microscópio Olympus SZX10. Olympus SZX10 40 páginas. Research high-class stereo microscope
Também para Olympus SZX10: Visão geral (24 páginas), Manual de instruções (36 páginas)

Olympus SZX10 Manual de instruções

9-2 Drop Prevention Collar SZX-R and Auxiliary Pillar SZH-P400/SZH-P600

TIP
NOTE
1
Assembly
c
2
Operation
CAUTION
To Move the Microscope Body Upward
1
Loosen the clamping knob of the focusing assembly to be moved upward.
2
At the desired height, tighten the focusing assembly clamping knob securely.
3
Loosen the drop prevention collar clamping knob, press the drop prevention collar tightly against the lower end of the
focusing assembly, and tighten the clamping knob securely.
To Move the Microscope Body Downward
First loosen the drop prevention collar, move the microscope body downward, and then move the focusing assembly.
NOTE
24
Downloaded from
ManualsNet.com
· The auxiliary pillar is to be used when observing a large specimen or when it is required to move the microscope
body upward for using a low-magnification objective with long WD.
· The drop prevention collar prevents the zoom microscope body from dropping when installed at a high position
using the auxiliary pillar and the clamping knob on the focusing assembly is loosened carelessly. This helps to
avoid accidental damage to the specimen or objective.
The static load resistance of the SZX-R is 7 kg at maximum.
d
a
b
When moving the microscope body around the pillar, never loosen both the focusing assembly
clamping knob and drop prevention collar simultaneously.
For the drop prevention collar to exhibit its full effect, clamp the focusing assembly and drop
prevention collar in close contact between each other, without leaving any space.
search engine
1
Mounting the auxiliary pillar
· Remove the pillar from the standard base and replace the pillar with
the SZH-P400 or SZH-P600 auxiliary pillar (see page 20 for the
mounting procedure).
2
Mounting the drop prevention collar
· Fit the drop prevention collar a onto the auxiliary pillar b .
Position the oblique illumination unit mounting groove c on
TIP
the front side of the drop prevention collar a and tighten the
clamping knob d .
When the specimen height is low or an objective with
NOTE
a short working distance is used, the drop prevention
collar a does not have to be mounted if you move the
microscope body downward. However, this reduces safety
that is assured by using the SZX-R drop prevention collar
a , so be always sure to hold the focusing assembly
firmly when loosening the focusing assembly clamping
knob.