Olympus PT 021 Manual de instruções - Página 32
Procurar online ou descarregar pdf Manual de instruções para Acessórios para câmaras Olympus PT 021. Olympus PT 021 38 páginas. For the digital camera camedia x-350
Imprimir páginatemperatures or direct sunlight may cause deformation,
discoloration or breakage of the Case and deterioration of the O-
ring. Wipe the inside of the Case with a soft cloth not causing any
fibers. Remove the O-ring, wipe off any salt, sand, dust, etc., and
also clean the O-ring groove and the O-ring contact surface in the
same way and then dry them. When an object with a sharp tip is
used to remove the O-ring from the groove, the O-ring may be
damaged and water leakage may be caused. Always use the
accessory pick for O-ring removal.
Q6 : How should I take pictures under water?
A6 : Please observe the following items for shooting under water.
(1) Fix the Case with the accessory hand strap to your wrist.
(2) When you place a finger onto the lens window, the finger will
appear in the photo. Pay attention to the position of your fingers
when holding the Case.
(3) When pressing the shutter lever, hold the Case securely with both
hands and operate the lever quietly to prevent camera shake.
(4) Look through the LCD monitor window on the rear of the Case to
confirm the picture and then press the shutter lever. Please note
that the optical viewfinder cannot be used, When the LCD
monitor is used, the battery is exhausted earlier. In order to avoid
losing shutter chances due to an exhausted battery, please always
replace a battery with a fully charged battery before each dive.
Q7 : How can I check for water leakage?
A7 : For confirmation, perform the advance test and the final test after
loading the camera. The advance test with immersing the Case
without the camera to the intended use depth to check for water
leakage is the most accurate test, but when this is difficult, it is
safer to perform this test even at a depth of 1 m or in a bathtub.
The final test also can be performed in a bathtub or a bucket.
Q8 : What are the causes for entry of water?
A8 : The main causes for the entry of water are shown below. Please
check them most carefully.
(1) Forgetting to install the O-ring
(2) The O-ring is partly or completely outside the groove.
(3) Damage, deterioration, or deformation of the O-ring
(4) Sand, fibers, hair or other foreign matter on the O-ring
(5) Sand, fibers, hair or other foreign matter on the O-ring groove or
the O-ring contact surface
E-31