Olympus PT-048 Manual de instruções - Página 5

Procurar online ou descarregar pdf Manual de instruções para Acessórios para câmaras Olympus PT-048. Olympus PT-048 32 páginas.

Chemicals which cannot

be used

Volatile organic solvents,

chemical detergents

Anticorrosion agent

Commercial defogging

agents

Grease other than

specified silicone grease

Adhesive

6 Jumping into the water with the Case in your pocket or in your hand,

throwing the Case from a boat or ship into the water, and other rough

handling may cause water leakage. Please handle with sufficient care,

when handing it over from hand to hand etc.

7 If the camera on the inside should become wet because of water

leakage etc., immediately wipe off all moisture and confirm the

operation after the Case is dried.

8 Please remove the O-ring when traveling by air. Otherwise air

pressure may make it impossible to open the Case.

9 For safe use of the digital camera in this product, please read the

"Instruction Manual" for the digital camera carefully.

0 When sealing this product, take sufficient care that no foreign matter

gets caught at the O-ring and the contact surface. It is caused for water

leakage.

a When you install your digital camera in the Case after taking pictures

in the water, it may cause the loss of transparency of the lens inside

even if you insert the supplied silica gel to the Case when drying the

camera is insufficient.

Do not clean the Case with alcohol, gasoline,

thinner or other volatile organic solvents or with

chemical detergents etc. Use pure water or

lukewarm water.

Do not use anticorrosion agents. The metal parts

use stainless steel or brass. Wash with pure

water.

Do not use commercial defogging agents. Always

use the specified desiccant silica gel.

Use only the specified silicone grease for the

silicone O-ring, as otherwise the O-ring surface

may deteriorate and water leakage may occur.

Do not use adhesive for repairs or other purposes.

When repair is required, please contact a dealer or

a service station of OLYMPUS IMAGING CORP.

Explanation

EN 5