Olympus PT-E03 Manual de instruções - Página 21

Procurar online ou descarregar pdf Manual de instruções para Acessórios para câmaras Olympus PT-E03. Olympus PT-E03 41 páginas. Underwater case for digital camera e-410/e-400

Imprimir página

2 Set the automatic pop-up setting of the camera to OFF. The camera's built-in flash is designed to pop

up automatically when shooting under low light or against backlight in any scene mode other than the

AUTO or underwater modes. This setting change is required to prevent this.

[Y]

[OFF]: The built-in flash will not pop up automatically.

3 Switch the electronic flash ON before switching the camera ON.

When using the electronic flash, be sure to turn it ON before turning the camera on.

Otherwise, if the automatic pop-up setting of the camera is ON and the camera is set to a scene mode

other than the AUTO or underwater modes, turning the camera ON before turning the electronic

flash on would cause the camera's built-in flash to pop up automatically. Always be sure to turn the

electronic flash ON before turning the camera ON.

4 Load the camera in the Case, and then

connect the hot shoe cable to the

camera.

CAUTION:

• For details on camera function setup, refer to the camera's instruction manual.

• If the camera's built-in flash pops up while the hot shoe cable is connected to the camera, it will interfere

with the hot shoe cable, either disconnecting it or causing a connection failure.

• When using a slave-type underwater flash from a non-Olympus manufacturer, pop the camera's built-in

flash up before loading it in the Case.

• Once the camera has been loaded in the Case and the Case has been sealed by closing the buckles, it is

no longer possible to pop up or retract the camera's built-in flash.

• When using an optional electronic flash with underwater case, a bracket is required to attach the electronic

flash case to this Case.

[AUTO POP UP]

EN 20