Olympus PT-E05 Manual de instruções - Página 25

Procurar online ou descarregar pdf Manual de instruções para Acessórios para câmaras Olympus PT-E05. Olympus PT-E05 42 páginas. Underwater case for digital camera e-520

Imprimir página

Insert the silica gel

Before sealing the Case, be sure to insert the silica gel bag in the space between the bottom of the

camera table and the inner surface of the Case. This will prevent fogging. Inset the silica gel bag laterally

with the sides folded down.

CAUTION:

• Insert the silica gel bag as far as it will go at the specified location and with the specified orientation. If the

orientation is incorrect, the silica gel bag will get caught when the Case is sealed and water will leak into

the Case.

• If the bag is only inserted part of the way, it will get caught by the O-ring when you try to seal the Case and

water will leak into the Case.

• Once silica gel has been used, the moisture absorption performance will be impaired. Always change the

silica gel when you open or close the Case.

Check the loading status.

Always perform the following final checks before sealing the Case.

• Does the zoom dial operate properly?

• Is the silica gel inserted all the way at the specified position?

• Are the O-rings and the O-ring contact surfaces free of dirt and other foreign matter?

• Are the O-rings installed properly?

• Is the Waterproof Port attached correctly?

• Is the TTL cable connector cap attached properly without loosening?

• Can the camera power be switched ON/OFF?

• Is the mode dial of the camera controllable?

• When using an external electronic flash with a TTL cable, check that the hot shoe cable is connected

properly and that the camera's automatic pop-up setting is set to OFF.

• Check that the camera's built-in flash is popped up.

Pay attention to the orientation.

EN 24