Axminster TS-200 Manual de instruções e lista de peças - Página 5

Procurar online ou descarregar pdf Manual de instruções e lista de peças para Serra Axminster TS-200. Axminster TS-200 17 páginas. 200mm table saw

......Location

Certain types of woods. Press boards, etc. produce hazardous dust emissions when being processed. For

this reason, processing procedures must be performed with an exhaust unit(air speed at the connection

points: 20m/s) Be sure to switch on the machine and the exhaust unit simultaneously. The main cable plug

must be connected as appropriate for the electrical installation and must have an earth lead(or a directly

earth conductor for 380 v). It is advisable to have a qualified electrical connections. Appropriate lighting must

be provided in the work area.

......The Operator

Read the operating manual carefully to prevent machine accidents. Never work while under the influence of

drugs, alcohol or medications. Wear tight-fitting work clothes, safety goggles and safety shoes and tie back

long hair. Remove rings, wrist watches and bracelets before working.

Ear protection is recommended. Never climb onto the machine table: the machine may fall and cause injuries.

Keep children and visitors out of the work area.

......Before working

Check that the sawing tool type is suited for the intended work. Immediately replace damaged or dull sawing

tools. Only work with the appropriate standard accessories. Always work with well sharpened sawing tools

increase the risk of wood kick back. Note the correct rotational direction. As a general rule, check that sawing

tool wrenches and other items have been removed. Check that the sawing tool can rotate freely and does

not contact the limit stop, the safety equipment, the work piece or other objects. Keep out of the kick-back

zone.

......While working

Wood must be hand fed uniformly and without jerking into the sawing tool, slightly more slowly when

processing hard wood or work pieces which produce large amounts of dust. Never move the work piece

during a processing operation. Avoid uncomfortable working stances to reduce the risk of contacting the

rotating sawing tool. Do not bend over the rotating sawing tool. Remove debris from the machine table only

when the machine is off. Never use the machine table as a work table while the sawing tool is rotating .

......After working

Never leave the machine operating without supervision. Remain at the machine until the sawing tool has

come to a complete stop. Remove debris and clean the machine and surrounding area so that the machine

is ready to use the next time.

......machine Maintenance

Unplug the mains cable before any mechanical or electrical work is per-formed or when the sawing tool is

changed. Regularly lubricate mechanical parts: threaded rods, gears, driving chains, hinges, sliding parts,

etc.

Grounding Instructions

Caution: This tool must be grounded while in use to protect the operator from electric shock.

In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current

to reduce the risk of electric shock. This tool is equipped with an electric cord having an

equipment-grounding conductor and a grounding plug. The plug must be plugged into a matching outlet that

is properly installed and grounded in accordance with all local codes and ordinances.

Do not modify the plug provided. If it will not fit the outlet, have the proper outlet installed by a qualified

electrician.

Improper connection of the equipment-grounding conductor can result in a risk of electric shock. The

conductor, with insulation having an outer surface that is green with or without yellow stripes, is the