Axminster TS-200 Manual de instruções e lista de peças - Página 9

Procurar online ou descarregar pdf Manual de instruções e lista de peças para Serra Axminster TS-200. Axminster TS-200 17 páginas. 200mm table saw

FIG 15

FIG16

Note: The maximum height adjustment must be reduced by 10 mm at pivot angles of 30ºor more.

Working with the circular table saw

Only use shape, uniformly and sufficiently crossed circular saw blades. Adjust the splitting wedge and fasten

it securely. Adjust the protective cover appropriately for the sawing tool thickness. Adopt a working stance as

indicated in the figure. Keep out of the danger zone. FIG 16

Feed the work piece with both hands (be sure to use the feeding rod near the saw blade) until it is behind the

splitting wedge. Secure longer work pieces so that they do not flip after the cutting procedure (i.e. with a

table extension). FIG 17

FIG 17

FIG 18

Use the flat edge of the longitudinal limit stop for work pieces narrower than 120 mm. Use a parallel

intermediate piece if necessary. Secure longer work piece so that they do not flip after the cutting

procedure(i.e. with a table extension) (FIG 18)

The diagonal limit stop can be mounted on the left or right hand side of the saw blade in the T-groove.

Diagonal cuts between 90º and 45º can be exactly made due to the optional diagonal positioning.( FIG19)

Diagonal positioning is made possible by the 90ºorientation of the two supporting surface of the limit stop.