Axminster RTC7030 Manual do utilizador - Página 9
Procurar online ou descarregar pdf Manual do utilizador para Ferramentas Axminster RTC7030. Axminster RTC7030 16 páginas. 305mm & 750mm sheet metal workers
Rolling
Start by removing the cover which protects the rollers then lower the rear roller by
slackening off the adjustment screws. (see figs 11 & 12) (see page 10)
Insert the workpiece between the upper and lower rollers and close up the gap between the
rollers using the adjusting screws, (fig 3), until there is a very slight clearance between the
workpiece and the rollers.
Lower the bottom roller using the adjustment knobs (see fig 12) then advance the
workpiece through the rollers by rotating the operating handle until contact is made with
the rear roller. Adjust the rear roller so that the work is slightly deformed as it passes
through the rollers. Make a series of passes through the rollers, closing up the rollers each
time, until the required diameter is achieved. The amount of bend that can be achieved per
pass through the roll depends on the type and thickness of the material being formed. (see
fig 13) (see page 10)
Wire can be rolled into rings by using one of the three grooves at the end of the rollers
(see fig 14).
Shearing Illustrations
Fig 5
Fig 6
Back stop
Clamping
screw
Support block
Operating Instructions...
Alternative position for backstop bar
2 hex bolts
Fig 7
Back stop
W
A X M I N S T E R
W H I T E
08