Axminster Euro Twist Pen Kits Manual de instruções - Página 6

Procurar online ou descarregar pdf Manual de instruções para Acessórios Axminster Euro Twist Pen Kits. Axminster Euro Twist Pen Kits 12 páginas.

Turning the Bodies ...

Move the dummy bushing away and reduce the diameter of the lower end of the upper pen

body over a distance of 5.6mm (7/32")to produce a 'snug fit' for the internal diameter of the

dummy centre band. ENSURE that the corner is SHARP. See Fig. 4

Carry out the finishing work on the bodies.

Remove the finished bodies from the pen mandrel.

General Assembly ...

Note. The Axminster Pen Assembly Press (Part no. 200205) is a very useful accessory for these

operations, as it gives greater control over the applied force and keeps the components in line.

Put a couple of drops of glue (added security) on the Centre Band and press it on to the prepared

journal at the lower end of the Upper Pen Body. Put aside to dry.

Line up the Lower Pen Body components as shown in Fig 5. Make sure the body and the tip are

aligned and gently but firmly, press the Ballpoint End Tip home. (Force Fit) Ensure the twist

mechanism is correctly oriented and put a guide mark (fine felt tip?) 21mm (13/16") from the

end as shown. (See Fig 6) Make sure the body and the mechanism are aligned and gently but

firmly press the twist mechanism into the body as far as the marked distance. (Force Fit)

NOTE. We suggest that the initial insertion is made 'short' . Screw the pen refill into the

mechanism, twist to fully extend and check how much further the pen tip needs to move to

give optimum protrusion. See Fig 6. Remove the refill and carry out the required

adjustment.

Twist mechanism

www.axminster.co.uk

Cap bushing

Upper pen body

5.6mm (7/32")

Dummy bushing

Centre bushing

Fig 4

Lower pen body

Fig 5

Tip bushing

Ballpoint end tip