ARC Audio XDi 6.2 Manual de instalação - Página 3

Procurar online ou descarregar pdf Manual de instalação para Altifalantes para automóvel ARC Audio XDi 6.2. ARC Audio XDi 6.2 4 páginas. Xdi series high performance component speakers

Imprimir página

Install the Tweeter

The tweeter comes with 2 different types of mounts.

Flush mount and Surface mount.

Flush Mount

Cut a hole in the panel you wish to install in. Assemble

the tweeter in the mount. Make sure the hole is large

enough for the tweeter and install it through the hole.

Firmly install the retainer to the back of the tweeter.

Reinstall the panel and point the tweeter at a location

between the driver and passenger at ear level.

Surface Mount

Hold the back piece for the mount in place and mark the

screw locations. Pre drill the screw holes and the hole

for the wire. Screw the mount to the panel tightly. Run

the wire through the hole and gently pull it until the

tweeter is fully seated in the mount. Install the retainer

and point the tweeter.

Crossovers

Install the Crossover in a dry location and secure it

firmly. Don't just drop it in the bottom of the door.

Wiring

When wiring this system it is important to make all

connections carefully and securely. Follow the instruc-

tions carefully. All audio connections have a + and -. If

one is wired backward the system will play but will

sound strange. One speaker will play Out of Phase

(backwards) from the others. You may notice a loss of

bass response and the vocals will not be in the center of

the sound field.

Connect the Woofer

Using the wire provided with the system connect the

positive and negative to the woofer. Run these wires to

the crossover and connect them to the terminals

marked Woofer + and -.

Connect the Tweeter

Connect the positive and negative to the amplifier

output. Run these wires to the crossover and connect

them to the terminals marked Tweeter +and-.

Connect the Amp

Connect the positive and negative to the amplifier

output. Run these wires to the crossover and connect

them to the terminals marked Input +and-.