Cino Fuzzyscan Manual de início rápido - Página 8

Procurar online ou descarregar pdf Manual de início rápido para Scanner Cino Fuzzyscan. Cino Fuzzyscan 17 páginas. Bluetooth cordless scanner
Também para Cino Fuzzyscan: Manual de início rápido (17 páginas), Manual de início rápido (15 páginas), Manual de início rápido (17 páginas), Manual de início rápido (17 páginas), Manual de referência rápida (12 páginas), Manual de início rápido (17 páginas)

Use FuzzyScan in SPP Mode

Establish SPP Master Connection

Ensure the battery is fully charged. Please go to the folder of "Hardware"

located in Bluetooth Advanced Setting of the remote host device to check

its device MAC address. Then prepare a 12-character Code 128 barcode

of the remote host device MAC address, or follow the step 4 to input MAC

address by scanning 12 option codes.

Ensure a virtual COM port is available in your remote host for connecting

the scanner. If not, please go to the folder of "Local Services" located in

Bluetooth Advanced Setting. Click the "Add Serial Services" to add one

more Bluetooth COM port.

Power on the scanner within radio range and ensure the status indicator

of scanner gives alternating red and green blinks (in "Uninstall" state).

If the scanner is not in uninstall state, please scan the "Uninstall"

command first. Then scan the "SPP Master Mode" command, and the

status indicator of scanner will turn steady red.

Scan a 12-character MAC address barcode, or scan 12 option codes and

"FIN" command to confirm your inputs. The scanner will give continuous

short clicks and the link indicator of the scanner will flash blue quickly

during the radio connecting process. If the PIN Code or Passkey is

requested for security connection, please enter "00000000" (default

setting).

The scanner will give 4 beeps in ascending tone to indicate the radio is

connected. At the same time, the link indicator of scanner will give 1 blue

blink per 2.5 seconds to indicate the scanner is in radio-connected state.

Please note that if the scanner failed to connect to the host device within

30 seconds, the link indicator will give 3 blue blinks per 2 seconds. But

the scanner is still continuing to discover the host device for another 30

seconds before go to sleep. In the interim, you still can scan "Uninstall"

command to revert the scanner to uninstall state. If the scanner goes to

sleep already, you just need to press the trigger to wake up the scanner to

continue the installation.

The installation procedures vary on different remote host devices,

operating systems and the Bluetooth software drivers. Please consult

your professional IT consultant to obtain necessary support if any

problem has been encountered during the installation processes.

Uninstall

SPP Master Mode