ARCA ArcaCash 2600 Instrução de trabalho - Página 6

Procurar online ou descarregar pdf Instrução de trabalho para Dispensador ARCA ArcaCash 2600. ARCA ArcaCash 2600 7 páginas. Front to rear dispense conversion

Imprimir página

unit. Restrain the PRC cable by running it through the plastic-coated retaining tabs. There are two

beneath the presenter and two along the length of the top unit.

48. Reconnect PRC cable to the power/controller pc board.

49. Verify that all wiring is appropriately restrained by the plastic-coated retaining tabs.

50. Reinstall the power/controller pc board back onto the dispenser and tighten screws.

51. Reinstall right side panel, verify no wires are being pinched and tighten screws. Note: It is essential that

the alignment pins in the sides of the 4

right side panel be properly mated to ensure proper alignment between the ADMs. The bracket should be

flat against the ADM side plates.

2.6 Reinstalling the Dispenser

52. Verify that the shoulder washers are properly positioned into holes marked (RA) and are tightened.

53. Lift dispenser onto front of tray and slide back until both slotted holes in the dispenser mounting brackets

engage the shoulder washers. Move cabling as necessary to prevent being snagged when sliding the

dispenser into position. Note: There are holes in the left side ball-bearing slide (near the safe) to push a

screwdriver through to hold the tray in the extended position. WARNING: Dispenser is heavy and

awkward. It is recommended that two people perform this step.

54. Reinstall and tighten the front dispenser mounting screws in forward holes (marked 'RA'). Note: The

dispenser mounting holes in the tray are marked 'FA' for front dispensing position and 'RA' for rear

dispenser mounting position.

55. Reconnect cables exiting the cable carrier chain back into the dispenser. Run cables back through the

gray cable clips in the bottom ADM. Close clips and use cable ties to route cables neatly and out of the

way to prevent snagging or pinching.

2.7 Power Up Sequence and Dispenser Mode Change

56. Verify that power switch is in OFF position.

57. Connect AC power source.

58. Toggle power switch to ON position. Look and listen. The dispenser should reset, both dispense indicator

lights in cosmetic door should flash and the shutter should cycle. LEDs on dispenser power/controller

board should flash 'UF' (indicating front dispense mode), then '00'

59. In RAS mode, reprogram the dispenser for rear dispensing. Depress and hold all three buttons (SW1,

SW2 and ST) on the dispenser power/controller board simultaneously; '00" should flash on LEDs.

Depress SW1 until 'A' is showing. Depress SW2 until '2' is showing. Depress ST once. Depress SW1

until '0' is showing. Depress SW2 until '1' is showing. Depress ST twice. LEDs should flash 'A201'. Note:

A201 indicates rear dispense setting vs. A200 which indicates front dispense setting. Toggle power

switch to OFF position.

60. Wait a few seconds before toggling power back on.

61. LEDs should flash 'H2', '-1', 'UR (indicating rear dispense mode)', '00', 'A4' and finally '00'. Dispenser

should reset and the shutter should cycle.

File - 000010

Printed copies of this electronically controlled document are valid only for the day in which it is printed

Work Instruction

and 5

ADMs and the matching holes in the lower flange of the

Page 4

10/11/2006 1:53:00 PM