Arcam DiVA P85/3 Manual - Página 4

Procurar online ou descarregar pdf Manual para Amplificador Arcam DiVA P85/3. Arcam DiVA P85/3 14 páginas.

Imprimir página
Arcam DiVA P85/3 Manual
Installation: A85 integrated amplifi er
VOLTAGE
SELECT
POWER INLET
1
2

Positioning the unit

Place your amplifi er on a level, fi rm surface.
Avoid placing the unit in direct sunlight or near sources of heat
or damp.
Ensure adequate ventilation. Do not place the unit in an
enclosed space such as a bookcase or cabinet as both of
these will impede air fl ow through the ventilation slots.

Connecting to loudspeakers

You can connect one or two pairs of loudspeakers to your
amplifi er, provided each pair is rated between 8–16Ω. If one or
both pairs have an impedance of less than 8Ω, the combined
load on the amplifi er falls below 4Ω and could cause an
overload. If so, the overload protection circuit engages and the
amplifi er will not work.
To connect one pair of loudspeakers, use the
SP1 and SP2 terminals
Both sets of loudspeaker terminals can be switched off by
pressing the
and
page 6) or the remote control (see page 9).
Your amplifi er is fi tted with loudspeaker terminals to BFA
(British Federation of Audio) standard specifi cation.
The terminal will accept spade terminals, bare wires or a
BFA plug. BFA plugs are available from your Arcam dealer. To
connect a bare wire or spade terminal, unscrew the red (or
black) part of the loudspeaker terminal fi rst.
Insert the wire or spade terminal and screw it back up.
CAUTION: Do not over tighten the loudspeaker terminals or
use a wrench, pliers, etc., as this could cause damage to the
terminals which will not be covered under warranty.
A85/P85
4
SP2
4 – 16 OHMS
TRIG
OUT
SP1
REMOTE
IN
+
–
R
3
4
4
button on the remote control. To switch
MUTE
independently, use the front panel switch
SP2
BFA loudspeaker terminals
L
INTEGRATED
R
+
–
L
PRE/PWR
PWR IN
PRE OUT
5
6
7
Connect the right speaker to the terminals on the back of
your amplifi er marked
marked
Connect your loudspeakers so that the red (positive/+) terminal
on each loudspeaker is connected to the red (positive/+)
terminals.
terminal on the amplifi er. Your loudspeaker cables may be
SP1
marked to show polarity (negative/– and positive/+), if not, then
the positive terminal can usually be identifi ed by a ridge or
coloured marking.
SP1
Now connect your loudspeakers' black (negative/–) terminals to
7
(see
the black (negative/–) terminals on the amplifi er.
Ensure that no stray strands of inner wires are allowed to touch
another cable or the amplifi er's casing. This can cause a short
circuit and damage your amplifi er!
L
R
RECORD
PLAY
RECORD
PLAY
OUT
IN
OUT
IN
TAPE 1
VCR/TAPE 2
DVD
8 9 bk bl bm bn bo bp
Arcam A85 amplifier
+
–
R
–
+
Right
speaker
Wiring your loudspeakers
and the left speaker to the terminals
R
.
L
L
PHONO
R
MM
MC
AV
TUNER
CD
AUX
bq
br
+
–
L
+
–
Left
speaker