CIPU CPCR786 Manual do Proprietário - Página 5

Procurar online ou descarregar pdf Manual do Proprietário para Aspirador de piscinas CIPU CPCR786. CIPU CPCR786 12 páginas. Robotic swimming pool cleaner

Imprimir página

GENERAL OPERATING INSTRUCTIONS

Remove the CLEANER by placing the carton

down and removing it from the box as shown.

If the Caddy Cart is included, the CLEANER

and the Power Supply will be premounted to

the cart.

1. Select the nearest 115V~ voltage AC outlet protected by RCD.

2. The control box must be fixed at a minimum distance of 3.5m from the edge of the swimming pool

minimum 2.5 meters overtop of top edge of pool (outside Zone 1 defined in IEC 60364-7-702).

operate the unit without fixing the control box first. The length of the standard CLEANER cable is 42 feet.

3. Connect the floating cable to the power supply control box.

Use only the original Power Supply manufactured by Splash.

Connect the floating cable to the control box as follow photo.

Make sure they are connected correctly. (The fitting on the

cleaner floating cable should be connected with the control box

by turn at the clockwise direction).

4. Place the CLEANER in the pool. It will slowly sink to the bottom of the pool as the air inside is released.

5. Connect the power supply to the GFCI protected outlet and switch it on. The CLEANER will run according

to the procedures set to do the cleaning cycle.

CAUTION - DO NOT switch on CLEANER when the CLEANER is out of water. This may result in damage to

the pump and drive motor seals, which will VOID the warranty.

6. Choose the program and start:

Page 5 of 12

and

Never

Power Supply

Connector