Axxent MS-200 Manual de operação - Página 2

Procurar online ou descarregar pdf Manual de operação para Sistema de intercomunicação Axxent MS-200. Axxent MS-200 4 páginas. Intercom systems

Imprimir página

Controls on the rear side

Left is the power cord outlet (10) and the fuse holder (11). In case the fuse

should blow, please make sure you replace it with the same type e.g. 230 V,

1 Ampère, slow blow (regular commercially available glass fuse, 5 x 20 mm).

Should the new fuse become defective again you most likely have to send in the

unit for repair. Further right is the voltage selector (12) which in Europe should

remain in the 240 V position. When switching to 120 V by accident the unit might

be damaged and no warranty claim will help.

LINE OUT: This is a 3 pin XLR male line level output providing a signal for

recording, loudspeaker feed etc. The channels to be recorded can be determined

by the close by switch (13).

The Beltpack BP-100

is the second important component of an intercom system: The beltpack

is–as the name indicates–normally worn on the belt, using the steel clip. In case

you break this rugged clip we recommend to order a new one as a replacement part.

The front side of the BP-100 carries the controls, while all

connectors are located on the rear side.

CALL-button (1), with light indicator. Below is the buzzer ON/OFF switch (2),

to generate an acoustical call buzz. In the middle of the panel is the 3-position

microphone switch: ON (permanently), PTT = Push To Talk and OFF (3). Finally the

volume control for the earphone (4) and the SIDE-TONE-control (5) for setting the

cue volume of your own microphone. For all these controls the same hints apply

as outlined for the master station MS-200.

ProAudio Technik Josef Becker · Zum Wartturm 15 · 63571 Gelnhausen (Germany)

Fon: +49-6051-9140-0 Fax: 9140-59

I N T E R C O M - S Y S T E M

Operation Manual

LINE IN: 3 pin XLR female line level inputs. Here again the channel selector is

located right hand (14)This input is also equipped with the (somewhat hidden)

level control VOL. The volume is adjusted with a mini crew driver.

CHANNEL B – These XLR connectors (male) carry the intercom connection

signals. The three XLR plugs are wired in parallel, which means you do not have to

care which of the connectors you use (15).

CHANNEL A – The same applies to channel A . Please make sure that you

only use high quality shielded microphone cable for the interconnection of the

components, thereby avoiding hum and noise.

Rear side of the Beltpack BP-100

Left is the 4 pin XLR male connector (6) for your headset. Right from this is the three

pin XLR input (7) for the microphone cable from the main station or from other

beltpacks and the 3 pin XLR male (8) connector for looping through the intercom

signals to further beltpacks, signal lights, or loudspeaker stations.

The Beltpack BP-100V

The diﬀerence between this model and the above described version BP-100 is

the lack of a piezzo buzzer, providing a vibration alarm instead of it. This vibration

alarm consists of a small rectangular unit with attached cable and a 3.5 mm

phone jack, connecting to the BP-100V. The vibration alarm unit can be carried

in your pocket and calls your attention in case the signal light is not noticed.

All other controls and connectors are identical to the beltpack BP-100.

[email protected] · www.proaudio-technik.de