Axxess AXDSPL-WR Manual de instruções de instalação - Página 2
Procurar online ou descarregar pdf Manual de instruções de instalação para Acessórios para automóveis Axxess AXDSPL-WR. Axxess AXDSPL-WR 20 páginas. 6-channel digital signal processor with water resistant enclosure
Imprimir página
PREFACE
The AXDSPL-WR interface can be used with either an aftermarket or factory system.
The interface can grow as your stereo system grows. Start off by adding a subwoofer,
then add on from there. Simply reference the Installation Options page to change the
interface to the new system. All 6 channels of the interface can be assigned however
needed for the installation at hand. If 6 channels of a subwoofer signal is needed, the
interface can do it. In the following section, Installation Options, choose the installation
type, then either click on the hyperlink, or reference that page number.
The interface provides a 12-volt 1-amp output to turn on aftermarket amp(s). If installing
multiple amps, an SPDT automotive relay will be required if the amp turn-on current of all
amps combined exceeds 1-amp. Use Metra part number E-123 (sold separately) for best results.
If using the interface to install just a sub amp, the factory amp can be retained for mids/
highs. If installing the interface in models with a factory amp, and bypassing the amp,
the amp must be unplugged.
In most cases the CAN Bus wires need to be connected in order for the interface to
communicate with the vehicle to turn on and provide an amp turn-on output.
Inside the interface is a 16-pin header port for adding an optional Bluetooth module, part
number AXDSPL-BT (sold separately). Page 7 will show the installation and use of this module.
2
INSTALLATION OPTIONS
Aftermarket radio system:
The AXDSPL-WR interface can be used with an aftermarket radio to improve the overall listening
experience for car audio enthusiasts. Installers will connect the RCA inputs from the interface to
the outputs from the aftermarket radio; Front, Rear. When using an aftermarket radio with the
interface, General must be chosen for the vehicle type.
(refer to page 5)
Stand-alone Bluetooth system:
The AXDSPL-WR interface and AXDSP-BT Bluetooth module can be used together as a stand-alone
system and used in just about any 12-volt DC application. Perfect applications would be classic car
installations where the dashboard cannot be altered, or in UTV vehicles. This can even be used inside
a home with a 12-volt DC power supply. The options are endless and only limited by ones creativity.
(refer to page 6)